535540

Datalogic PowerScan 7000 2D Manual

20
Zoom out
Zoom in
Previous page
1/28
Next page
12 PowerScan™ 7000 2D
The imager’s housing may also be cleaned the same way.
Inspecting Cords and Connectors
Inspect the imager’s interface cable and connector for wear or other signs
of damage. A badly worn cable or damaged connector may interfere
with imager operation. Contact your dealer for information about cable
replacement. Cable replacement instructions are included below.
Troubleshooting
The imager automatically performs self-tests whenever you turn it on. If
your imager is not functioning properly, review the following Trouble-
shooting Guide to try to isolate the problem.
• Is the power on? Is the green aiming illumination line on?
If the green aiming illumination line isn’t illuminated, check that:
• The cable is connected properly.
• The host system power is on (if external power isn’t used).
• The trigger works.
Is the imager having trouble reading your
symbols?
If the imager isn’t reading symbols well, check that the symbols:
• Aren’t smeared, rough, scratched, or exhibiting voids.
• Aren’t coated with frost or water droplets on the surface.
CAUTION
Do not submerge the imager in water. Do not
use abrasive wipes or tissues on the imager’s
window – abrasive wipes may scratch the win-
dow.
Never use solvents (e.g., acetone, benzene,
ether, or phenol-based agents) on the housing
or window – solvents may damage the finish or
the window.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Datalogic PowerScan 7000 2D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Datalogic PowerScan 7000 2D in the language / languages: English as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info