Manual Danfoss TPOne-M (page 17 of 28) (English)

654610

Zoom out

Zoom in

1/28

Danfoss Heating

Installer Settings

Hot Water

Setup

The TPOne-M can be used as a single channel

programmable thermostat to control the

temperature regulation of the heating system only

or as a two channel programmable thermostat

to control the heating and the time schedule of

a domestic hot water circuit. The domestic hot

water selection will have been chosen in the

startup wizard on initial installation. Choose this

setting after installation to switch the domestic

hot water option on/o.

Default: Set at startup

Note: Settings in the menu which are required for

domestic hot water are only accessable if the Hot

Water Setup is switched on. TPOne-M controls

only the time schedule for domestic hot water and

should always be used with a suitable hot water

cylinder thermostat.

Control Type This allows the thermostat to be set to run in On/

O mode or in chrono-proportional 3, 6 or 12

cycle rate.

Default: Chrono 6

Note: for condensing boiler control tests have

shown that boiler eﬃciency is signiﬁcantly

improved when controlled by a chrono-

proportional type controller

On both, one on ground floor and another on first floor, of our TPOne-M we are having exactly the same problems with. When you press 'Home Mode' the +1,2,3 hour boosts is no longer appearing or happening. Scheduled times not operating when set on schedule. Theses units came fitted in our new build property that we purchased July 2022. Submitted on 16-11-2024 at 11:51
Reply Report abuse
What I need to do if show external sensors fail and I can set up temperature? Submitted on 9-11-2021 at 21:19
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Danfoss TPOne-M in the language / languages: English as an attachment in your email.

The manual is 2,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Danfoss TPOne-M Manual

Product: