745210
10
Zoom out
Zoom in
Previous page
1/14
Next page
12
5.3.2 USING LFE INPUT
When connecting your DALI SUB P-10 DSS to smaller speakers, e.g. the DALI EPICON 2, we
recommend a crossover point of approximately 80 Hz. This must be entered in the menu system
of your (pre-) amplifier. You might need to enter the ‘small’ setting when selecting type of front
speakers in the AV receiver menu.
Connecting larger speakers (typically floor-standing front speakers) will allow you to choose a
lower crossover point, and to define your speakers as ‘large’ in the menu system.
If in doubt about the capacity of your speakers, we recommend setting the crossover point quite
high, defining your speakers as small, and finally reducing the crossover point to the lowest
possible position while maintaining an even bass with no drop-outs.
5.4 CINEMA / HIFI MODE
DALI SUB P-10 DSS allows you to choose between two sound modes, one which is optimized
for watching movies, and another for listening to music. See Figure 3.
For a realistic and powerful rendering of e.g. explosions in a movie, you should set the sound
mode to CINEMA. This will amplify the lowest frequencies to ensure a realistic experience.
For a neutral and very linear performance, you should set the sound mode to HIFI. This will
ensure a precise rendering of all the details of the music, while optimizing the integration with
your front speakers.
To toggle between the two sound modes, simultaneously press the ‘+’ and ‘-’ buttons on the
back of the amplifier.
5.5 POWER
The POWER switch is the main ON/OFF switch. We recommend switching ‘OFF’ the subwoofer
when it is not to be used for extended periods. When changing connections, always disconnect
the mains voltage from the subwoofer. We recommend that you ALWAYS turn ‘OFF’ the POWER
switch on the rear side of the subwoofer BEFORE turning off the mains switch.
5.6 ON / STAND BY MODE
The subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an
input signal is detected (given that the POWER is set to ‘ON’ and the POWER MODE switch is
set to ‘AUTO’). When the subwoofer is ‘ON’, the ON/STANDBY LED will light up green. If an input
signal is not detected for approximately 20 minutes, the subwoofer will go into standby mode
and the ON/STANDBY LED will light up red.
Setting the POWER MODE switch to ‘MANUAL’ means that the subwoofer can only be switched
‘ON’ or ‘OFF’ by means of the remote control.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dali SUB P-10 DSS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dali SUB P-10 DSS in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info