643443

Daihatsu Terions J100 Manual

39
Zoom out
Zoom in
Previous page
1/1009
Next page
CAUTION:
• Never allow the tachometer terminal to touch ground. It
could result in damage of the ignition system.
• As some tachometer are not compatible with this igni-
tion system, it is recommended to confirm the compati-
bility with your unit before its use.
• Care must be exercised to ensure that no connection is
made on terminals except for those specified.
Even slight contact of the other terminal causes serious
malfunction.
(5) Connect a timing light to the resistive cord of the No. 1
cylinder (at the timing belt side)
(6) Connect the T (!1) terminal and E (!3) terminal in the
SST which was connected, using the following SST.
SST: 09991-87403-000
CAUTION:
• Care must be exercised to ensure that no connection is
made on terminals other than that specified.
Even slight contact of the other terminal causes serious
malfunction.
(7) Start the engine.
(8) Ensure that the engine revolution speed is stable.
If the engine revolution speed becomes unstable, pro-
ceed to check ISC system.
(Refer to the EM section.)
(9) Check to see if the ignition timing mark of the crank-
shaft pulley is aligned with the indicator provided on
the timing belt cover, using a timing light.
If the ignition timing mark on the crankshaft pulley is
not aligned with the indicator provided on the timing
belt cover, adjust the ignition timing by turning the cam
angle sensor attaching position.
MA–21
ET
JMA00058-00000
JMA00059-00048
JMA00060-00049
TDC 0° BTDC 2° ATDC 2°
(10) Adjustment of ignition timing
q Loosen the cam angle sensor attaching bolt.
w Adjust the ignition timing to the specified timing by turning the cam angle sensor.
e Tighten the cam angle sensor attaching bolt to the specified tightening torque.
Tightening Torque : 14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
r Ensure that the ignition timing is not disturbed by tightening of the attaching bolts of the cam
angle sensor.
Readjust the ignition timing, if the timing is not in the specified position.
(11) Stop the engine.
(12) Remove the tachometer.
(13) Remove the SST from the diagnosis connector.
CAUTION:
• Care must be exercised to ensure that no connection is made on terminals except for those speci-
fied.
Even slight contact of the other terminal causes serious malfunction.
(14) Check the idle speed.
(See the check of the idle speed procedure in this service manual.)
JMA00061-00000
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daihatsu Terions J100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daihatsu Terions J100 in the language / languages: English as an attachment in your email.

The manual is 41,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info