467056

Daewoo DWS-60 Manual

10
Zoom out
Zoom in
Previous page
1/12
Next page
BATTERY INSTALLATION FOR REMOTE SENSOR UNIT
1. Lift off the bracket stand of the remote sensor unit by releasing the 2 xing snaps at the bottom;
2. Use a small Philips type screwdriver to remove the battery cover screws;
3. Insert 2 pieces of AAA size batteries according to the “+” and “-” polarity marks shown in the battery compart- ment and
then close the battery door.
WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE
1. Insert x2 AAA batteries rst to the main unit. The temperature display shows - - . – while the wave icon will keep blinking for
2 minutes indicate the main unit is in sensor searching mode.
2. In a second step, insert the x2 AAA batteries into the sensor unit. The LED on the front panel will start ashing at
a rate of one time per around 2 seconds indicates channel-1 is in use.
3. While the LED is ashing, press once the [CH] key will change the sensor channel setting to 2. Keep toggle on
[CH] key can change channel setting up to 3. The LED is blinking at a frequency to indicate the channel setting. i.e.
continuous blinks 2 times indicate channel-2 is selected.
Note: If user does not press any key for 10 seconds, it will exit the channel setting mode and
transmit the RF signal. The main unit will register the temperature reading.
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an auto-scroll function. While the auto-scroll function is set, the unit will automatically cycle to display
the temperature of each remote sensor for 6 seconds.
1. To retrieve manually the specic sensor temperature and humidity reading, press CHANNEL key until desired channel number
is displayed.
2. To enable auto-scroll function, use CHANNEL button to toggle channel 1,2,.,. until auto scroll icon appears beside the channel
indicator.
DCF 77 RADIO CONTROLLED CLOCK
The radio-controlled time is calculated by the Cesium Atomic clock of Braunschweig (ofcial clock of Germany). Then the time is
coded and transmitted from Mainingen - near Frankfurt - via a signal on DCF-77 (77.5 kHz). The transmitting range of the signal
is 500 km, which means that most of Western and Central Europe is covered by this signal. Within this range the received time is
completely accurate. Once sensor signal(s) are received, the wave icon will ash to indicate that the receiving unit starts to receive
the DCF radio controlled time signal. Radio Controlled
wave icon can indicate 4 levels of signal status:
Once the time signal is received, the wave icon will stay on the LCD, and time and calendar will automatically be updated.
Note: During the 10-minute time signal reception, all manual settings will be suspended. If setting is
desired, press once [ + ] key to deactivate the reception. You can also press and hold the same key for
2 seconds to manually activate the reception in normal mode.
SET THE CLOCK & CALENDAR
1. Press & hold [ ] button for 2 seconds to enter clock setting mode. Flashing 24 hours will appear.
2. Press [ + ] or [ - ] button to switch between 24 hours and 12 hours format, and then press [ ] button to
conrm.
3. The hour digits will ash. Use the [ + ] button to increase by one hour or [ - ] button to decrease by one hour to your desired
hours. Holding down either button will change the increment rapidly. Press [ ] button to conrm.
4. The minute digits will ash. Use the [ + ] button or [ - ] button to set your desired minutes. Holding down either button will
change the increment rapidly. Press [ ] button to conrm.
Note: Every change of minute digit will automatically reset the seconds to zero.
10
… 10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Daewoo DWS-60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Daewoo DWS-60 in the language / languages: English, Spanish as an attachment in your email.

The manual is 2,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info