595166
6
Zoom out
Zoom in
Previous page
1/22
Next page
Drive Partner for your Safety
8
BX1000 / BX1000 Plus User Guide
www.d-teg.com
9
INSTALLATION INSTALLATION
Parkyourvehicleonaatlevelsurface.
Turn off the engine before installing the BX1000 / BX1000 Plus.
1. Insert the SD memory card into the SD card slot.
Please make sure to disconnect the power cable when
inserting or ejecting the SD memory card.
2. Attach the BX1000 / BX1000 Plus using the provided double
sided tape. The surface must be clean and dry before you
install. We recommended to install the product behind the
rear view mirror on the front windshield.
3. Adjust camera view. Make sure the lens has an unobstructed view.
Check from outside the vehicle to check the camera angle.
Arrange the power cord neatly alongside
the windshield and door pillar trim.
Use the provided wire splice clip as
seen in the picture on left.
4.BX1000 / BX1000 Plus unit requires a continuous 12-24V DC
power source from the vehicle. Plug in the power.
The provided power cord cable route should be from the left
side of the BX1000 / BX1000 Plus towards your power source.
NOTE
When the impact is light like a minor bump in the road, the G-sensor may
not recognize the impact and as a result it may not begin recording automatically.
Test and set your own G-sensor level for your vehicle.
NOTE Adhesive tape will not stick well with dust or oil, etc.
Warm temperatures are best (above 30 degrees centigrade ) when applying tape.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for D-Teg Smarty BX1000 Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of D-Teg Smarty BX1000 Plus in the language / languages: English as an attachment in your email.

The manual is 7,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info