498399
14
Zoom out
Zoom in
Previous page
1/84
Next page
REMOVING THE CYBEX PALLAS-FIX
Perform all installation steps in reverse order.
Note! By following these steps the vehicle’s seat pad will be protected and the ISOFIX
connectors will be prevented from being stained or damaged. Damages and stains
could obstruct a smooth operation.
Release the ISOFIX connectors (o) by simultaneously pulling and slinging
back the red release buttons (y).
Pull the child seat out of the ISOFIX-CONNECT guides (u).
Rotate the connectors (o) by 180°.
Pull the adjusting handle (c) located on the main frame (w) of the CYBEX PALLAS-fix
and push the connectors (o) into the child seat until they are completely hidden.
12
SECURING THE CHILD
Note! On some car seat covers made of sensitive material (e.g. velour’s, leather etc.)
the use of child seats may lead to traces of wear and tear. To avoid this, put a blanket
or a towel underneath the child seat.
Place the CYBEX PALLAS-fix on the respective seat in the car.
– Please make sure that the backrest (a) of the CYBEX PALLAS-fix rests flat against
the backrest of the car seat so that the child seat is under no circumstance in a
sleeping position.
When using the ISOFIX anchorage points (j) in the car, make sure that
the backrest (a) of the CYBEX PALLAS-fix is perfectly aligned and in full
contact with the upright part backrest of the car seat. The position can
be adjusted with the adjusting handle (c) located under the seat cushion
(d) on the main frame (w) of the child seat.
Should the headrest of the vehicle seat interfere, please pull it out completely, turn
it around or take it off entirely (exceptional case, refer to the section “THE BEST
POSITION IN THE CAR”). The backrest (a) optimally adjusts to almost any inclination
of the vehicle seat.
Warning! The backrest of the CYBEX PALLAS-fix should rest flat against backrest of the
car seat. Pushing the booster rearwards the seat should be tightly pressed against
the seat. For the best possible protection of your child, the seat must be in a normal
upright position!
POUR RETIRER LE CYBEX PALLAS-FIX
Procédez à toutes les étapes dans l‘ordre inverse.
Note! En suivant ces étapes, l‘assise du véhicule sera protégée et les connecteurs
ISOFIX ne pourront pas être endommagés, ce qui pourrait empêcher une utilisation
facile.
Date de sortie les connecteurs ISOFIX (o) en tirant simultanément et
d‘élingage dos les boutons de déverrouillage rouge (y).
Tirez le siège enfant hors des guides ISOFIX-CONNECT (u)
Tournez les connecteurs de 180°.
Tirez la poignée d‘ajustement (c) située sur l‘armature (w) du CYBEX PALLAS-fix
et repoussez les connecteurs (o) à l‘intérieur du siège enfant jusqu‘à ce qu‘ils
disparaissent complètement.
ATTACHER CORRECTEMENT L’ENFANT
Note! Sur certain siège de voiture en velours, cuirs, alcantara, etc. le siège auto peut
parfois laisser des traces. Pour éviter cela, mettez une serviette ou une couverture
sous le siège enfant.
Placer le CYBEX PALLAS-FIX sur le siège choisi.
Assurez-vous que le dossier (a) du CYBEX PALLAS-FIX soit bien adossé contre le
dossier du siège du véhicule, de façon à ce que le siège enfant n‘est pas dans
une position sommeil.
Quand vous utilisez les points d‘ancrage ISOFIX (j) du véhicule, assurez
vous que le dossier (a) du CYBEX PALLAS-FIX est bien aligné et en contact
complet avec le dossier vertical du siège du véhicule. La position peut
être ajustée avec la poignée d‘ajustement (c) située sous l‘assise (d) sur
le chassis (w) du siège enfant.
Si l‘appui-tête du siège du véhicule gêne, veuillez le tirer en position haute
maximale, le retourner, ou le retirer complètement (cas exceptionnel, veuillez
vous référer à la section „LA MEILLEURE POSITION DANS LE VEHICULE“). Le dossier
(a) s‘ajuste parfaitement à presque toutes les inclinaisons de dossier du siège
véhicule.
Avertissement! Le dossier du CYBEX PALLAS-FIX doit être en contact complet avec
le dossier du siège véhicule. Pousser l‘assise du siège vers l‘arrière sur le fauteuil
du véhicule pour que le siège soit fermement pressé contre le fauteuil. Pour une
protection optimale de votre enfant, le siège doit être en position assise droite.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cybex PALLAS-FIX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cybex PALLAS-FIX in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 8,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info