690881
11
Zoom out
Zoom in
Previous page
1/46
Next page
INSTALLATION INSTRUCTIONS II18
ALPHA, INSTALLATION INSTRUCTIONS 080619B
Connecting the Brewer Wiring - Twin Brewers
1 Remove the back cover.
2 Loosen the strain relief on the back of the brewer.
Brewers Operated with 220-240 Volts
Feed the 220-240 Volt power cable into the brewer.
Connect the wires on the power cable to the left
terminal block inside the brewer.
Skip to step 3.
Brewers Operated on 120 Volts
Two 120 Volt power cables (not supplied) are required
to connect the twin brewer for use with a 120 Volt power
supply. See the ELECTRICAL SCHEMATIC for the power
supply requirements.
Remove the four jumper wires connected between
the left and right terminal blocks inside the brewer.
Be sure to tighten the other existing wires back into
place. Keep the jumper wires in the event that the
brewer needs to be converted back to 220-240 Volt
operation.
On both terminal blocks, uncap the white wire
connected to the “N” terminal and connect the bare
wire to the “C” terminal.
Feed the 120 Volt power cords through the strain
relief, into the brewer.
Connect one power cord to the left terminal block
and one to the right terminal block.
3 Tighten the strain relief and replace the back cover.
Left
terminal
block
Jumper
wires
Right
terminal
block
Strain
relief
Back
panel
WARNING: Do not connect the power cord to the
power supply until instructed to do so.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Curtis G3 Series Alpha Decanter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Curtis G3 Series Alpha Decanter in the language / languages: English as an attachment in your email.

The manual is 4,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info