13
ENGLISH
If the valve hole of the pressure weight part is clogged, punch it with the cleaning pin
How to
disassemble the
pressure weight
-The valve hole of the pressure weight that allows steam to escape should be checked regularly to
ensure that it is not blocked.
If you use the valve hole of pressure weight as it is blocked, the hot steam or any hot content within
the cooker can cause injury.
※Do not use a Cleaning Pin for other use except cleaning the valve hole of the pressure weight.
▶After the Lock/Unlock handle is locked(located in “Lock”) turn the pressure weight counter-
clockwise while pulling it up, and pull it put
▶Punch the clogged valve hole with the cleaning pin and reassemble it by turning it clockwise.
▶When the pressure weight is properly assembled, it can freely be turned.
Pressure Weight
Cleaning Pin
※Attached on the
bottom of the unit
Soft steam cap
Alien
Substance
Do not touch the surface of the soft cap right after cooking. You can get burned.
Do not try close the top cover by force. It can cause problems.
1. Check to see if the inner pot is correctly
placed inside the main body.
2. To close the top cover, place the handle in
the “Unlock” position as shown in the
picture on the right.
3. If there are hot foods in the inner pot,
the top cover might not lock properly. In
this case twist the pressure weight and
allow the steam to release then try to
lock the handle.
❶
Detach the soft steam
cap like the picture.
❶
Separate dew dish
❶
Separate cleaning pin
Attached on the bottom of the
unit from main body as shown
in picture
❷
Separate cover
as the arrow
points.
❸
Use brush kit. You
can easily clean a
drain use the ditch
cap and tough pat
to clean.
❹
When using
cleaning pin, pull
out cleaning pin
and make it meet at
right angles.
❺
Only use for the
valve hole of the
pressure weight.
❷
Separate the drain
ditch cap by pushing
it down.
❸
Clean the drain ditch
cap and dew dish with
a neutral detergent.
❹
Clean the drain ditch
cap with brush kit..
❺
Securely put in the
dew dish after
cleaning.
❷
Press the hook in the back, and follow the arrow to
detach and clean. Make sure you clean frequently
with a sponge or a neutral detergent.
❸
Assemble the went
so that it fits into the
groove perfectly.
❹
After you attach the
soft steam cap to fit
into the groove, press
“A” part firmly to
assemble the soft
steam cap into the
product.
※When fitting the rubber
packing into the plate,
please make sure the
packing is facing the
correct direction.
HOW TO CLEAN
How to clean the soft steam cap
How to clean dew dish
How to use cleaning pin and brush kit
Cautions when top cover does not close perfectly
