648531
3
Zoom out
Zoom in
Previous page
1/8
Next page
EN  •  3
3. Normal charging will be indicated by the following lights: start (1), bulk charging (2), absorption charging (3) or mainte-
nance charging (4). When the maintenance charging lamp illuminates the battery is fully charged. Charging will start 
if the voltage drops. The charger can normally be connected for months. Reconditioning is indicated by the lamp (5) 
illuminating. 
4. If the battery leads have been connected incorrectly, the reverse polarity protection system will ensure that neither the 
charger nor the battery is damaged and is indicated by lamp (0).
5. If nothing happens. If the lamp indicating the setting and the power lamp remain lit but no other lamp illuminates, the 
connection to the battery or chassis may be poor or the battery may be faulty. Another cause may be a lack of voltage in 
the AC Power Supply. Begin by improving the connection between the battery and charger.
6. Charging can be stopped at any time by disconnecting the charger’s AC cord. Always disconnect the AC cord before 
disconnecting the battery leads. When you stop charging a battery installed in a vehicle you should always disconnect 
the battery lead from the chassis before disconnecting the other battery lead.
IMPORTANT INFORMATION
Please note that the battery pack in the 24V system in most cases consists of more than one battery. They are linked up to 
the 24V system, but the individual batteries generally have a lower voltage. Therefore it is important for the charger to be 
connected correctly. 
BATTERY TYPES AND SETTINGS
The charger is programmed according to “PROGRAM DESCRIPTION” with xed settings and can easily be set for 
different types of batteries or conditions. The following recommendations should, however, only be seen as guidelines. 
Please consult the battery manufacturer for further instructions. 
Settings are made by pressing the “MODE-button “ and stepping forward one press at a time until the required mode is 
reached, the button is then released. After about 2 seconds the charger activates the selected mode. The selected mode 
is saved in a memory in the charger and remains there even if the charger is disconnected from battery and mains.
NORMAL
NORMAL - Normal setting for wet batteries, maintenance free and for most Gel batteries. Some Gel 
batteries prefer a slightly lower charging voltage. Please consult the battery manufacturer when in 
doubt.
SUPPLY
SUPPLY - The charger operates at a constant voltage. This is the maintenance mode for applications 
where maximum capacity from the battery is important, like oor sweepers and golf carts. Note that 
the Spark protection function is suppressed in this mode.
RECOND
RECOND - This mode is used to recover deep discharged ooded batteries where you could expect 
a stratied acid (high acid weight in the bottom, low on top). Check with battery manufacturer when 
in doubt. 
Use this mode with care, because the high voltage will cause some water loss. 32V is normally no 
problem for electronics in 24V system. Consult your supplier when in doubt. Life of light bulbs will be 
reduced at higher voltage. Try to disconnect light from the battery during this phase. Maximum effect 
and minimum risk for electronics is achieved by charging a disconnected battery.
CHARGING PHASES
MXT 14000 AE charges and analyses in eight fully automatic steps.
The battery charger has an 8-step fully automatic charging cycle:
Desulphation
Desulphation with pulses recovers sulphated batteries. Indicates with lamp 1.
Start (Lamp 1)
Start mode for the charging cycle. The start phase continues until the battery’s terminal voltage has risen above the set 
limit, at which point the charger switches to bulk charging. If the terminal voltage has not passed the voltage limit within 
the time limit, the charger switches to fault mode (lamp 0) and discontinues the charging. If so, the battery is faulty or its 
capacity is too large. 
Bulk (Lamp 2)
Main charge when 80% of charging takes place. The charger delivers maximum current until the terminal voltage has risen 
to the set level. Bulk has a maximum time, at which point the charger automatically switches to Absorption.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ctek MXT 14000 AE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ctek MXT 14000 AE in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ctek MXT 14000 AE

Ctek MXT 14000 AE User Manual - German - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info