648454
8
Zoom out
Zoom in
Previous page
1/12
Next page
8
Analysis
Tests the self-discharge. If the self discharge is too high, the charging is interrupted
and error mode indicated.
Recond
Reconditioning of deeply discharged batteries. This step is used to restore deeply
discharged open vented batteries. With increased charging voltage over a limited
time, the voltage is allowed to rise so that the battery starts to emit gas. As a result
you get a mix in the battery that is good both for its capacity and service life. Note
that the battery may emit explosive gases during this step. Recond takes place
between the analysis and maintenance steps. When choosing the Recond-mode,
thechargerwillrstchargeyourbatteryuptofull-charged.Whenthisisdone
the charger will start the Recond and the upper Recond-lamp will lit. The charger
reconditions the battery between 30 min and 4 hours depending on the need of the
battery. Once the recond is done, the charger will switch into maintenance-mode
(greenlightforfullycharged).ThebottomRecond-lampwillstillbeonasareminder
that you have chosen the Recond.
Maintenance charge Float
Charging with constant voltage.
Maintenance charge Pulse
The state of charge varies between 95% and 100%. The battery receives a pulse
whenthevoltagehasdroppedtoapredenedlevel.Thiskeepsthebatteryintrim
when not in use. The charger could be connected for months at a time. Check the
water level in the battery if possible. The charger measures the terminal voltage
continuously to determine whether a charge pulse should be started. If the battery is
loaded and/or the terminal voltage drops, the charger starts a charge pulse so that
theterminalvoltagerisestothesetlevel.Thechargepulseisthennishedandthe
cycle is restarted. If the terminal voltage drops even lower, the charger automatically
reverts to the beginning of the charge cycle.
CHARGING TIME
The table below shows the estimated time for bulk charging.
Battery size (Ah) Time to ~80% charge (h)
2
2
8
8
20
4
60 12
140 28
TEMPERATURE PROTECTION
The chargers are protected against overheating. The power reduces when the
ambient temperature increases.
The charger may be perceived as being hot during charging. This is completely
normal, although you should avoid placing it on a sensitive surface.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ctek Multi XS 4003 model 1035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ctek Multi XS 4003 model 1035 in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ctek Multi XS 4003 model 1035

Ctek Multi XS 4003 model 1035 User Manual - German - 12 pages

Ctek Multi XS 4003 model 1035 User Manual - Dutch - 10 pages

Ctek Multi XS 4003 model 1035 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info