735847

Crivit SW 5755 IAN 327402 1904 Manual

21
Zoom out
Zoom in
Previous page
1/82
Next page
23GB/IE
• Do not expose the batteries to extreme condi-
tions (e.g. radiators or direct sunlight). Other-
wise there is an increased risk of leakage.
• Batteries can be life-threatening if swallowed.
Therefore, always store them out of reach of
small children. Medical attention must be sought
immediately if a battery has been swallowed.
Danger!
• Handle damaged or leaking batteries with
extreme caution and dispose of them properly as
soon as possible. Wear gloves when doing so.
• If you come into contact with battery acid,
wash the affected area with soap and water. If
battery acid gets in your eye, rinse it with water
and seek medical attention immediately!
• The connection terminals must not be short-cir-
cuited.
Replacing the batteries
CAUTION! Observe the following
instructions to avoid mechanical and
electrical damage.
Danger!
There is a battery LR03 in the item. You can
replace the battery if it stops working.
1. Raise the display on the side, and carefully re-
move it. The battery is at the back of the display.
2. Slide the battery carefully out of the battery
casing and replace with a new one.
Note: Make sure that the battery is inserted
properly and completely in its casing.
3. Insert the display and the cable connections
into the casing once again.
Note: Make sure that the display is correctly
inserted in the casing once again.
Assembling the stepper
Step 1:
Insert both plastic feet into the pipe on the back
of the frame. The ribbed contact surfaces lie on
the floor and the sharp ends point backward
(Fig. C). To anchor it, a self-tapping screw is in-
serted into the pre-drilled hole on the underside
of the frame.
Note: Make sure that the pre-drilled hole in the
frame and the plastic foot are placed exactly on
top of each other.
Step 2:
The adjustable screw is screwed into the thread
on the front of the stepper.
With the help of this screw, you may adjust the
step height of the tread surfaces.
To increase the step height, turn the adjustable
screw in a clockwise direction. To lower the step
height, turn the adjustable screw in an anticlock-
wise direction.
Step 3:
Remove the computer from the stepper by pulling
it upwards.
Place the supplied battery in its appropriate
compartment on the underside of the computer.
Ensure that the polarities are correctly aligned.
Connect the computer to the connector on the
casing and insert it once again. Make sure
that the cable does not get pinched during this
procedure.
Step 4:
Observe the maximum stretch length of
the straps.
The shorter the straps, the greater the effort
expended.
• Shorten the straps by locking the rubber hose
with the safety ball into place (Fig. B).
IMPORTANT! Make sure not to shorten
the straps too far. Do not go past the
“MIN.” marking!
• Hook the metal hook into the eyelet on the
stepper frame and screw in the fastener on the
hook tightly (Fig. D).
Important! Before training, check that
the straps are securely fitted, and that
the hook is safely and tightly screwed
in. Caution! The eyelets are secured for
tensile loads upwards only, and may
not be subjected to transverse loads.
There is a risk of injury, or damage to
the stepper.
When you are not training with the straps,
unhook them from the eyelets to avoid tripping
over them.
Check whether all screws and nuts are securely
tightened.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit SW 5755 IAN 327402 1904 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit SW 5755 IAN 327402 1904 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 4,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info