736848
13
Zoom out
Zoom in
Previous page
1/27
Next page
11
GB/IE
Then fold the inner tent 2 and roll it
together.
Collect all of the parts together carefully
before you pack the tent. You should count
the parts in order to ensure that none of them
have been mislaid or lost.
After the tent has been rolled up, pack it
carefully into the carrying bag.
§Repair instructions
Damages on the outer tent
Clean the area which has to be glued and
wipe it dry thoroughly.
Cut the self-adhesive repair patch 24, 25
according to the size of the hole.
Note: Make sure that the patch is larger
than the hole and that it overlaps the edges.
Round off the edges of the repair patch and
remove the protective film.
Place the patch over the hole and press
down firmly.
Use the transparent foil to repair the window.
Glue the edges with a transparent glue from
a specialized shop. Depending on the glue
that you will use, might this repaired area no
longer be water and wind tight.
Damages on floor / inner tent
Holes in the tent floor or inside the tent can
be sewn up with the aid of the enclosed
piece of material 19 22 , 26 , 27 . Place
the fabric in the according colour on the
hole and sew it with a sewing machine.
We recommend to use a short stitch length
to avoid that the fabric tears. Afterwards,
treat the seams with a seam sealer from a
specialized trade.
Fibreglass pole damaged / replacing
elastic band in fibreglass pole
There are 2 fibreglass poles included with
different sizes. Please make sure to use the
correct pole when replacing.
Cut the elastic band which is inside the
fibreglass pole and pull it out.
Take the new white-red elastic band 18 out
of the included repair set.
Tie a double knot at one end and pull out the
other end through the fibreglass poles.
Tip! We recommend to carefully heat up the
end with a cigarette lighter to avoid that the
ends frays out and that the band slides better
through the poles.
Please make sure to be outdoors when doing
this and please also pay attention that you
don’t offend the fire safety regulations of your
camping site!
You should also make a double knot here,
after you have pulled out the elastic band
through the last fibre pole.
Elastic band for pegs missing or damaged
Remove the damaged band and replace it by
a new one that you will find in the enclosed
repair set. Pull the black elastic band 17
through the loop and tie the ends to a knot.
§Cleaning and Care
m CAUTION! Never wash the tent in a
washing machine. Otherwise the product
may lose some of its ability to keep out water.
m CAUTION! Never use petrol, solvent or
other cleaning agents. Otherwise there is a
danger of damage to the product.
Condensation can form in all synthetic tents;
you should therefore air the tent as frequently as
possible in order to counteract this.
Remove any dirt from the tent with a soft
sponge and clean water.
Please allow all parts to dry thoroughly
before you repack the tent. This will prevent
the formation of mould, bad odours and
discolouration.
If the zipper sticks when being opened or
closed, spray it with silicone spray.
The product may lose some of its ability to
keep out water with frequent use. Therefore
you should spray the tent regularly with a
waterproofing agent (available in DIY shops,
camping shops etc.).
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crivit HG00412 IAN 273647 IAN 273648 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crivit HG00412 IAN 273647 IAN 273648 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info