Manual Crivit 28795L-17 - IAN 292900 (page 15 of 48) (English, German, Dutch, French, Spanish)

735265

Zoom out

Zoom in

1/48

diseases and physical symptoms, especially with ad-

vancing age.

Cool Down

Just as a warm-up should be performed before each

training session, a cool-down should take place after a

unit. A Cool Down starts the relaxation phase; the op-

erating temperature of the body will come back down

and shows the transition of stress relaxation.

The cool-down should last at least 10 minutes (as the

Warm Up) and is controlled slowly dropping down to

the lowest level. The pulse rate should drop as low as

possible.

Stretching

As already mentioned, you can stretch before/during

the warm-up your muscles easily. After the training you

should definitely stretch your muscles. A stretching

afterwards returns the muscle to its original length, thus

preventing muscle shortening. The more strenuous the

training has been, the more important is the stretching

afterwards.

Particularly important is the stretching for the exercised

muscle groups. Stretching should be noticeable for the

muscle addressed, but it should never hurt. Stretching

should take 20 to 30 seconds per muscle.

Start your training with about 7 - 8 reps per exercise

set. Increase the number of repetitions according to

your individual preferences slowly to 11 - 12 reps per

set. If you notice that your muscles are tired, reduce the

scope of your training. Ideally train 3 - 4 times a week.

However, be sure that between individual exercises one

day of rest is inserted so that the muscles and the body

are able to recover sufficiently.

Also, perform all exercises with a stable body centre.

The spine (particularly the lumbar spine) must be kept

straight, so that the individual vertebrae are held in the

biomechanically correct position, e.g. to protect the

disc against faulty loads.

Do not train with momentum and / or jerkily. Perform

all exercises in a smooth and controlled manner. Note

that in case of improper or excessive training negative

effects on your health are possible.

14.2

14.214.2

14.2 Exercise instructions

Exercise instructionsExercise instructions

Exercise instructions

First of all, you should practice standing on the unit

when it is switched off. First stand on both legs with

your body up straight. Then lift a leg and stretch your

arms out. Change legs. Do this to get the feeling of

standing on the unit.

Body tension will always be in the core when you are

in the normal standing position on the vibration plate.

For this, keep your back straight and bend your knees

slightly. The leg muscles are now also slightly tightened.

Never train with straight arms or legs, always keep

them bent.

Stand in a normal position on the unit with your feet

about shoulder-width apart. Go into the squat position

by bending your legs and move your buttocks back-

wards and downwards in the same movement. To sta-

bilise yourself, raise your arms upwards in front of your

body. Hold the squat position and then return to the

standing position.

(D) Biceps

Stand in a normal position on the unit with your feet

about shoulder-width apart. Take one handle of the

stretch tube in each hand at about waist height. Now

bend your arms and lift your hands upwards. Make

sure that the elbows remain stable against the sides of

your body throughout the movement. Hold this position

briefly and then return to the initial position.

(E) Dips

Sit upright in front of the unit. With your thumbs point-

ing inwards, place both hands on the training plate

and straighten your arms to lift your body into the air.

Bend your arms back and lower your body. Now lift it

again. You can perform this exercise with bent legs or

 as a variation  with stretched legs.

(F) Sit-ups

Lie with your back on the training plate and place your

feet on a chair or similar, place your feet in front of

your body on the floor with bent knees for more stabil-

ity or lift your feet for a more strenuous variation. Now

hold your arms to the side of your head or chest and

lift your upper body towards your knees. Hold this

position briefly and then return to the initial position.

(G) Push-ups

Support yourself with both hands as shown on the

training plate. Keep your body straight and stiff and

bend your arms now. Then straighten your arms again.

You can vary this exercise by doing it either with bent

legs on the knees (see figure) or with straight legs and

straight back on the feet.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Crivit 28795L-17 - IAN 292900 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 3,19 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Crivit 28795L-17 - IAN 292900 Manual

Product: