460569
8
Zoom out
Zoom in
Previous page
1/28
Next page
BATTERY INSTALLATION AND ACTIVATION
Warning:
•Do not mix old and new batteries.
•Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel cadmium) batteries.
•For maximum performance in normal conditions we recommend using good quality alkaline batteries. When
temperatures are below 0°C, alkaline batteries can lose power resulting in a loss of remote transmission. If you
reside in an area that experiences frequent temperatures below freezing, we recommend using lithium 
batteries to minimize the loss of transmission.
Battery installation of Base Unit
•Open the battery door at the back of the base unit and insert (2) AA batteries according to the polarity
markings. Replace the battery door.
•Insert the end of a paper clip into the hole in RESET and push the button.
•Set the clock and calendar as follows.
Setting the Calendar, Clock, °C / °F:
•When either the clock or calendar is being displayed, press and hold the MODE button for 3-4 seconds until 
the year display is flashing
•Press + or – to set the year
•Press MODE to display the date
•Press + or – to set the month and day
•Press MODE to display time
•Press + or – to set the time
•Press MODE and the display will show 12 hr
•Press + or – to set your clock to 12 hr or 24 hr time format
•Press MODE and the temperature field will be flashing
•Press + or – to select °F or °C format
•Press MODE to lock in the settings
Note: If you set the time and date after initial activation, the accuracy of the rainfall history data may be affected.
Reset the unit to clear the history by pressing the RESET button then set your desired time and date.
•Press the RE-SYNC button.
•Position the Rain Collector/Remote Sensor close to the base unit.
Battery installation of Rain collector
•Press the hook and open the rain collector unit outer case and remove the inner cover to access RESET/RE-
SYNC buttons.
•Using a coin, unscrew the battery door at the bottom of the rain collector and insert (2) AA batteries 
according to the polarity markings.
•Press the RESET button.
•Replace the battery door.
•Remove the tape from the pendulum inside to
allow it to move freely.
•Close the outer case.
Note :Make sure the battery door is closed
securely to prevent water leakage.
•When the OUT temperature is shown on the display
of the base unit, synchronization between the base unit and the remote sensor is complete.
P.8
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cresta 9321 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cresta 9321 in the language / languages: Dutch as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info