618062
33
Zoom out
Zoom in
Previous page
1/42
Next page
190
WARNING: Always wash the instrument in fresh water
after using.
NOTE: Please always wash the instrument in fresh water
after using.
The buttons do not need any particular care; never grease
them with oil or spray of any kind.
NOTE: Check the battery case housing compartment
through its transparent lid; should any signs of moisture be
visible, please have the instrument checked by an authori-
zed Cressi-sub retailer.
Should you notice any possible anomaly in functioning, do not
use the instrument to dive and have it checked by an autho-
rized Cressi-sub retailer.
Related topics:
5.1. - Battery replacement.
7. - Warranty.
5.1. – Battery replacement.
Replacing the battery is easily done by the consumer, not
requiring special service. It must be done any time the instru-
ment’s display shows the run-down battery symbol, both
fixed and flashing (picture 2 a-b),as already seen in this
guide.
WARNING: By replacing the battery, all information rela-
ting to de-saturation, time and date will be cancelled. Reset
the time and date, in order to get correct entries in your
computer’s logbook. Please do not replace the battery
when de-saturation is in progress, since all information rela-
ting to de-saturation computing would be cancelled. In this
case, please check the amount of de-saturation hours and
do not dive after battery replacement during a correspon-
ding amount of hours. After battery replacement, all settings
go back to the values set at the factory (Dive Air program:
F02=21% and PO2=1.4 bar, maximum depth alarm on 132
ft., not working).
To replace battery, unscrew the transparent battery cover on
the back of the instrument by use of a coin (picture 38).
Remove the lid and check battery and its encasement. Should
you note traces of corrosion due to water entry, have the
instrument checked by an authorized Cressi-sub dive retailer.
If everything appears in good condition, remove battery by
holding the computer face down. Replace battery complying
with its polarity (note that an incorrect polarity will cause the
losing of information on calibre and memory!) and replace the
battery encasement’s lid as well (picture 39). The battery
encasement is watertight and is not connected to the instru-
ment’s core; before closing the cover, check that there is no
soiling on it and apply a thin layer of silicone lubricant to the o-
ring. (picture 40 a-b).
fig. 38
fig. 39
Manuale ARCHIMEDE II 2008:Manuale 6 26-06-2008 8:26 Pagina 190
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cressi Archimede II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cressi Archimede II in the language / languages: English as an attachment in your email.

The manual is 4,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info