498195
14
Zoom out
Zoom in
Previous page
1/16
Next page
14
Before calling your nearest Service Office, look at this list, to find a possible solution to your problem.
My appliance will not fill or take in detergent...
Is the machine plugged in and switched on?
Is the socket OK? Try another appliance in the socket.
Is the fuse in the machine plug OK? If not, replace it.
Did you check the water supply was flowing before connecting the
hoses to the appliance inlet valves? (see,‘Hot and Cold Fill
Connection’).
Are the hoses correctly connected, unkinked and the water supply
taps fully turned on?
Have you pressed the On/Off button?
Have you closed the door firmly?
It will not pump out the water...
Has the drain hose been installed correctly? (see,‘Connect to a
Drainage System’).
Is the hose kinked?
If you have connected your appliance to a sink waste system
ensure that you have cut out the membrane on the U bend pipe
fitted to the sink and check the unit is not blocked with lint.
The door will not open...
Has the programme finished?
Your appliance has an interlocking door system which cannot be
opened when a programme has been selected, the machine switched
‘ON’ and the indicator light is illuminated.
On completion of a programme the indicator light will take
approximately 1-2 minutes to go out before the door can be opened.
The door release is stuck...
Switch off the mains button, press gently on the door handle to
unlock the latch, pull handle to open the door.
It’s Leaking...
Are the fill hoses tightened correctly?
Perhaps the washers are not sealing properly?
Is the standpipe blocked?
Or is your household drain blocked?
If you cannot clear the blockage you will need to call a plumber.
Steam is coming from the dispenser drawer...
During hot washes the machine is designed to vent steam from the
dispenser drawer during hot washes.
The clothes are not dry enough...
Did you use a short spin programme on a non-synthetic load?
Did the water pump out? Check your waste plumbing setup.
Was the wash load out of balance?
The programme takes a long time...
Some programmes do take a long time.
Other things which can extend programme times include:
Low water pressure
Low temperature of the incoming hot water
It makes a noise or vibrates during spin...
Your appliance will make some noise, especially during spin cycles.
Small loads of heavy or bulky items (towels etc) can occasionally cause
out of balance conditions, but the machine will usually sort itself out. If
the noise is excessive you should check the following:
Has the transit bracket been removed?
Have you removed loose items such as
coins etc... from the pockets as these can rattle about inside the
appliance drum and cause damage.
Have you adjusted the feet to stabilise the appliance?
The dispenser drawer will not close properly...
Is the drawer clogged with detergent?
Suds are coming from the dispenser drawer...
Have you used the correct amount of detergent suitable for
automatic washing machines?
If you have used the wrong type,flush out your appliance by selecting a
rinse programme.
Follow instructions on the detergent pack, taking into consideration
load size, soiled loads and water hardness.
There is water in the fabric conditioner compartment...
Clean dispenser drawer and compartments.
If your Machine Does Not Spin...
Your machine has detected an unbalanced load and has
finished the programme without completing the spin. Do not
immediately call out a service engineer. Redistribute the washed
clothes by hand and reselect the appropriate spin only
programme.
NOTE: If washing only one item add another to help balance
the load.
Something wrong with your appliance
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Creda W120FW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Creda W120FW in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info