Manual Create Windlight Curve DC (page 9 of 72) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

789612

Zoom out

Zoom in

1/72

ENGLISH

ASSEMBLING AND HANGING THE FAN

Cotter pin

• If you wish to extend the hanging length of your fan, you must remove the hanging ball

from the downrod provided to use with an extended downrod (included).

(If you wish to use the downrod, please proceed to instructions below.)

• To remove the hanging ball, loose the set screw on the hanging ball and remove the pin

and bolt. Lower hanging ball and remove stop pin. Slide hanging ball off the original

downrod, and slide it down the longer downrod (the top of the downrod should be noted

as having a xing screw hole; use this hole when setting the xing screw).

• Insert stop pin into top of extended downrod and raise hanging ball.

• Be sure that the stop pin aligns with the slots on the inside of the hanging ball, tighten

the xing screw securely.

Tip: To prepare for threading electrical wires through the downrod, apply a small piece of

electrical tape to the ends of the electrical wires. This will keep the wires together when

threading them through the downrod.

• Loosen the xing screws and nut at the top of the motor housing. Remove the pin and

bolt from the downrod (if you have not already done so). Slide the downrod through the

canopy.

• Tread electrical wires through the downrod and pull extra wire slack from the upper end

of the downrod.

• Place the downrod into the motor housing yoke and reinsert the pin and bolt that were

previously removed. Tighten the xing screws and nut securely.

• Lower the canopy to the motor housing.

Cotter pin

Adapter

Fixing screw

Bolt

Decorative cover

Hanging

ball slot

Canopy

Electrical

wiring

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Create Windlight Curve DC in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 4.77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Create Windlight Curve DC Manual

Product: