Manual Create Wind Easy (page 10 of 64) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

789615

Zoom out

Zoom in

1/64

ENGLISH

Locking

MOUNT AND HANG THE FAN

Electrical

wiring

Floron

Ball coupling

Embellisher

Screw

Adapter

Fixing screw

Locking

• If you want to extend the suspension length of your fan, you must remove the hanging ball

from the rod provided for use with the extension rod (included).

(If you want to use the downrod, follow the instructions below.)

• To remove the hanging ball, loosen the hanging ball set screw and remove the pin and

bolt. Lower the hanging ball and remove the stopper pin. Slide the hanging ball out of the

original rod and slide it down the longest rod (it should be noted that the top of the rod has

a hole for the set screw, use this hole when inserting the set screw).

• Insert the stopper pin into the top of the extended rod and lift off the hanging ball.

• Make sure the stopper pin aligns with the slots on the inside of the hanging ball, securely

tighten the set screw.

Tip: To make it easier to feed the wires into the bar, wrap some electrical tape around the

wires. This will help you hold them together as you insert them into the bar.

• Loosen set screws and washer on top of motor housing. Remove the pins from the bar (if

you haven't already). Insert the rosette through the bar.

• Pass the cables through the bar and pull the excess cables from the top of the bar to tight-

en them.

• Place the bar inside the motor housing and insert the pins you removed earlier. Tighten the

set screws and washers.

• Lower the rosette onto the motor housing.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Create Wind Easy in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 2.74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Create Wind Easy Manual

Product: