818975
14
Zoom out
Zoom in
Previous page
1/201
Next page
WARNING
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing serious
personal injury.
7.3 LUBRICATION
NOTE
Replace the gearbox oil after you operate the machine for
50 hours for the first time, then replace the oil every 500
hours.
Brand Gear-
box
Moto
type
Gearbox
ratio
Oil
quantity
Oil brand
82ZT132 SP600 AC 32 0.6L GL-5
85W-140
7.4 TORQUE VALUES
WARNING
Particular attention must be given to tightening the drive
wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade,
which can cause serious damage or personal injury.
Torque values are given below:
Part Ft-lbs. Nm
Wheel (lug) nuts 83-118 112-132
Blade spindle bolt 114-118 155-160
Lug nuts only -It is recommended that these be checked after
the first 2 hours of operation, initially, every 100 hours and
following removal for repair or replacement.
7.5 SEAT BELT MAINTENANCE
Inspect the seat belt system (all seat, seat belt parts, seat pan
and seat pan latch) daily prior to mowing for signs of any
damage. These parts should be replaced if any parts indicate
signs of:
cuts
fraying
extreme or unusual wear
significant discoloration due to UV exposure
dirt or stiffness
abrasion to the seat belt webbing
damage to the buckle, latch plate or hardware
any other problem
If the seat belt is to be cleaned, use soap and water. Do not
use carbon tetrachloride, naphtha, etc., as these will weaken
the webbing. For the same reason, do not bleach or dye the
webbing. Replace seat belt if worn or damaged.
7.6 ROPS MAINTENANCE
ROPS Inspection
NOTE
Inspect the ROPS after the first 20 hours of operation.
Check the torque of the ROPS mounting bolts. Tighten
the bolts to the correct torques (M12, 95N.m) if
necessary.
Inspect the operators seat and the mounting parts for the
seat belt. Tighten the bolts to the correct torque as shown
below, if necessary, and replace parts that show wear or
damage.
Inspect the seat latch to make sure it is secured and
functioning properly. Adjust or repair, as necessary.
Possible damage to the ROPS
If the unit has rolled over or the ROPS has been in some other
type of accident (such as hitting an overhead object during
transport), the ROPS must be replaced to retain the best
protection. Following an accident, check the ROPS, the
operators seat, the seat belt, seat belt mountings and seat
latch for possible damage. Before operating the machine,
replace all damaged parts.
NOTE
The ROPS structure’s protective capability may be
impaired by structural damage, overturn or alteration. Do
not remove or alter any of the ROPS parts. Do not attempt
to weld or straighten ROPS. Failure to adhere to these
instructions could result in severe injury or death.
7.7 BATTERY PACK MAINTENANCE
Your Cramer mower is powered by a battery pack which,
when maintained properly, will provide years of useful life.
For proper care, adhere to the following instructions:
Always charge batteries after each use.
Whenever a battery pack is fully discharged and turned
off, it is best to recharge the battery as soon as possible.
Over-discharge of the battery pack means the battery life
will be shortened and the battery may become
permanently damaged. There is no need to fully charge; it
will be beneficial even if you only charge the battery pack
for 5-10 minutes. It is best to recharge it within 24 hours.
Check that battery cables are securely tightened to
batteries each time you service the battery.
Keep grass, dirt and debris from collecting near battery
terminals and in battery area.
Charge batteries indoors in a well-ventilated and dry
location away from sparks or flames. Never expose
charger to rain, vapor or liquid.
Charge only lithium batteries provided by Cramer.
Do not touch uninsulated portion of charger (terminal
pins) or of output connector.
Do not use with defective cords and wires. Replace
defective cords and wires immediately.
14
English
EN
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cramer 82ZT132 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cramer 82ZT132 in the language / languages: All languages as an attachment in your email.

The manual is 4.79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info