818973
13
Zoom out
Zoom in
Previous page
1/422
Next page
Refer to Slope Guide, when determining the degree of slope to be mowed. It is strongly recommended that the
operator drive the machine off of the slope, using extreme caution, if any sign of loss of traction is detected. Wait
until the condition that caused the problem is resolved before attempting to operate on the slope again. Terrain
conditions can affect traction, resulting in possible loss of control of the machine. Some of the conditions to be
aware of are:
1. Wet terrain
2. Depressions in the ground (e.g., holes, ruts, washouts)
3. Mounds of dirt
4. Certain types of soil (e.g., sand, loose dirt, gravel, clay)
5. Grass type, density, and height
6. Extremely dry conditions
7. Tire pressure
The attachments mounted to the mower will also affect the way it handles on a slope. Be aware that each
attachment’s characteristics vary.
These are just a few examples of situations where caution must be used when operating on a slope. There are
many other possibilities too numerous to mention. Remember to always exercise extreme caution while operating
on any slope.
5 ELECTRICAL SYSTEM
5.1 ELECTRICAL SYSTEM SAFETY
Remove key and batteries, and read owners
manual before adjusting or repairing unit.
Always remove key and batteries before working on
this unit.
Always remove key and batteries when transporting
unit.
Keep unit free of grass clippings, leaves and other
debris. DO NOT spray water to clean unit. Use only
compressed air. Wear adequate eye and hearing
protection when cleaning the unit.
Always wear safety glasses and protective gear
near battery. Use insulated tools.
Clean battery compartment, drive motor
compartment, mower deck, seat, etc., of all dirt
and debris. Do not use solvents, hard cleaners or
abrasives.
With key in ON position, mower blade can
engage when deck blades ON/OFF switch (PTO) is
engaged, even if drive motor is not turning. Keep
area clear of bystanders when engaging deck blade
ON/OFF switch.
All maintenance and storage areas should be
properly ventilated in accordance with applicable fire
codes and ordinances to avoid fire hazards.
Never allow flames, sparks or smoking near
batteries.
Keep batteries out of reach of children.
Always keep protective shields, covers and guards
in place and securely fastened. If they become
damaged, repair or replace immediately. Never
modify or remove safety devices.
5.2 ELECTRICAL SYSTEM
INFORMATION
The Cramer mower is powered by an 82-volt electrical
system. It consists of the following components:
1. Blade controller (1)
2. Blade motor (2)
3. Drive controller (1)
4. Accelerator - right (1)
5. Accelerator - left (1)
6. Digital display (1)
7. Wheel motor (2)
8. Battery pack (1)
5.3 DIGITAL DISPLAY
The function of the digital display, located on the control
panel, is to provide electrical system information to the
operator. It gives detailed information in the form of
pattern, codes and number.
123456
78
9
13
English EN
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cramer 82ZT107 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cramer 82ZT107 in the language / languages: All languages as an attachment in your email.

The manual is 7.63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info