768917

Cosatto Ooba Manual

5
Zoom out
Zoom in
Previous page
1/50
Next page
7 - adjusting the height of the handle
Press the button (a) in the centre of the handle and lift the handle (b) or lower the handle (c) as
required. Release the button when the handle is in the desired position.
8 - reversing the handle position
The handle position can be reversed. This is useful if the pushchair is used on uneven ground. As
this may make the pushchair harder to steer so Cosatto recommend returning the handle to its
original position for use on a flat surface.
To reverse the handle position, simultaneously lift the levers (a) and push the handle forward (b)
until a “click” is heard and the handle is locked in the reverse position.
Note: The handle will need to be raised (See step 7) if the seat unit is fitted.
9 - folding the chassis
Before folding the chassis ensure the front wheel swivel locks are released (See Step 5).
Ensure the handle is not in the reversed position. When first folded the handle should locate
between the large wheels (d).
Press the button (a) in the centre of the handle and push the handle down (b) to its lowest position.
Simultaneously lift the levers (c) then push the handle down (d) as far as it will go.
Push the folding button, marked with a 1, with your thumb (e) whilst lifting the folding handle,
marked with a 2, (f). Lift the chassis off the floor slightly to allow the front legs to fold inwards (g)
to complete folding process.
10 - erecting the carry cot
Slide the frame bars, using the straps (a), until the frame bars fit into the cut-outs in the carry cot
base (b).
Fit the carry cot liner to the carry cot by attaching the zip fasteners (d & e). Note: The carry cot has
two sets of zips around the top edge. Fit the carry cot liner to the lower zip. The top zips are for the
carry cot apron and the carry cot hood.
Place the mattress in the carry cot (f).
Turn the carry cot mountings downwards (g) until they lock in place.
11 - fitting and removing the carry cot
Place the carry cot on to the mounting points on each side of the chassis. Push down (a) until a
“click” is heard and the mountings are locked in place.
Note: The carry cot can only be fitted rearward facing.
To remove the carry cot from the chassis, press the buttons on each side of the mountings (b) then
lift the carry cot free (c).
12 - using the carry cot
Zip the carry cot apron to the carry cot (a) and secure both ends of the apron flap (b) to the hinge
by fasten the press studs.
To lift the carry cot hood press the buttons (c) on each hinge then lift the hood upwards (d).
To lower the hood, press the buttons (e) on each hinge then push the hood downwards (f).
The frame at the top of the hood can be used as a carrying handle (g).
13 - fitting the carry cot raincover
Lay the raincover over the carry cot as shown. Attach the fastener straps under the pushchair handle
hinge (a).
There is a flap on top of the raincover to allow access to the carry cot handle (b).
Unfasten the zips around the raincover to allow access to inside the carry cot (c). Refasten the zips
to close the raincover insuring the zips meet centrally at the top of the handle (d).
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cosatto Ooba at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cosatto Ooba in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 9,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info