751453
32
Zoom out
Zoom in
Previous page
1/36
Next page
EN - 29
11. TROUBLESHOOTING


below, then you should:
 
 Turn off the water supply.
 
FAULT  
Your machine will not start.
It is not plugged in. Insert the plug into the socket.
The fuse is faulty. Replace the fuse.
Mains supply is cut off. Check the mains supply.
Start/Pause button is not pressed. Press the Start/Pause button.
The programme dial is in the Stop
(off) position. Turn the program dial to the desired position.
The door of your machine is not
closed properly. Close the door of your machine.
Your machine does not
discharge
Drain hose is clogged or twisted. Check the drain hose.
Pump filter clogged. Clean the pump filter.
Your machine vibrates.
The feet have not been adjusted. Adjust the feet.
Transit bolts have not been
removed. Remove the transit bolts from your machine
Your machine only has a small
amount of laundry inside.
This will not prevent the operation of your
machine.
Your machine is overloaded with
laundry or the laundry is not
distributed evenly.
Do not overload your machine. Make sure the
laundry is spread out.
Your machine is located on a hard
surface.
Avoid installing your machine on a hard surface.
When installing your machine, leave a
2 cm gap between walls or hard surfaces.

the detergent drawer.
Too much detergent has been
used
Press the Start/Pause button. To stop the foam,
dilute one tablespoon of softener into 1/2 litre of
water and pour into the detergent drawer. Press
the Start/Pause button after 5-10 mins
Wrong detergent used. Use detergents produced only for automatic
washing machines in your machine.

result.
The laundry is too dirty for the
programme you have selected.
Select programmes appropriate for your laundry’s
level of dirtiness. (See page 21 programme table)
Not enough detergent used. Use the amount of detergent as instructed on the
packaging
There is too much laundry in your
machine.
Check that the maximum capacity of your
Washer Dryer is not exceeded.
As soon as the machine is
loaded with water, water
discharges.
The end of the water drain hose is
too low for the machine. Set the water drain hose to an appropriate height.
No water appears in the
drum during washing.
No fault. Water is in the unseen
part of the drum. - .
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Corbero CLSV961420T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Corbero CLSV961420T in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Corbero CLSV961420T

Corbero CLSV961420T User Manual - Spanish - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info