632803
24
Zoom out
Zoom in
Previous page
1/44
Next page
Edition 05/2014 - X-ONE - page 24
SACOME, CONFIDENTIAL Document,
it is forbidden to duplicate or communicate this document without previous authorization.
10 ALARM MESSAGES AND SOLUTIONS:
Cleaning alarm:
When the message "compulsory cleaning" appears on the display, the user need to start an automatic
cleanning on each groups (one after the other).
If it does only partially (1 group instead of 2, for example) or if it does not, the machine will no longer be used
and the message "Warning cleaning groups" remain permanently displayed on the display.
This message will disappear when all groups have been cleaned.
The machine comes back to NORMAL MODE.
Cleanning Gr : X SVP
After 250 coffees on one group, the display shows «Please Cleaning Gr: X»
The machine is usable, but the message will not disappear until the cleaning has not been made. To remove the
alarm, simply run an automatic cleaning (see chapter: use)
Nota:
Automatic cleaning is always possible even if there is no message on the display.
Filling up time out:
The high level probe SN did not detect water within the programmed time (250 sec).
Possible reasons: Water inlet solenoid valve must be cleaned.
Water inlet solenoid valve does not work.
Water high level probe is disconnected.
Water inlet tap is closed.
Solution: After checking up, cut the mains then put it back.
Boiler temperature alarm message
The electronics detected a temperature > 140 °C for more than 5 seconds in the boiler.
Alarm message disappears when temperature decreases 2°C under the limit.
Temperature probe open
The electronics does not detect the temperature probe.
Possible reasons: Reconnect or replace the temperature probe.
Check temperature probe cable, replace if necessary
Mother board may be damaged
Check the connector on the mother board
Flowmeter alarm Gr X
The electronics does not receive group X flowmeter information.
Possible reasons: No water in the flowmeter
Damaged cables
Damaged flowmeter
Coffee too fine
The water inlet tap is closed.
Water softener maintance alarm:
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Conti X-One at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Conti X-One in the language / languages: English as an attachment in your email.

The manual is 3,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info