542391
42
Zoom out
Zoom in
Previous page
1/48
Next page
42
4.Pull the retaining bracket towards the front and keep it
pushed upwards.
5.Fold the grill element upwards, until it clicks into place.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
: Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
: Risk of electric shock!
Work on the appliance electronics may only be performed by
a specialist.
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
$ %
D
D
& '
Problem Possible cause Remedial action
Electrical function is faulty (e.g. indicator
lamps do not light up)
Fuse defective Check fuses in the fuse box and replace if
necessary
Liquid or runny dough runs to one side Appliance not installed level Check the appliance installation (see
the Installation instructions)
Appliance no longer works,:‹‹ flashes in
the clock display
There was a power cut Reset the time of day (see
section: Electronic clock)
:‹‹ flashes in the clock display,
“rrr” appears in the temperature display
The power supply was interrupted while
the appliance was in operation
Press the KJ clock function button. Reset
the time of day (see
section: Electronic clock)
“E011” appears in the temperature display Permanent assignment of a button Cancel the permanent assignment of the
button and press the KJ clock function
button
The temperature display shows, “EXXX”,
e.g. E300
Internal fault in the appliance electronics Press the KJ clock function button. If the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Appliance operation is not possible, D
and -- appear in the temperature display
The appliance has been locked Deactivate the lock
(see section: Childproof lock)
Appliance operation is not possible, D
and -†˜ appear in the temperature display
The appliance controls were automati-
cally blocked
Deactivate the permanent lock (see
section: Childproof lock)
The appliance does not heat up, the two
dots flash in the clock display, and ‚‡‹©
appears in the temperature display, for
example
A button combination was actuated Switch off the appliance, press and hold
the ± info button for 3 seconds, then press
and hold the KJ clock function button for
4 seconds, then press and hold the ± info
button again for 3 seconds
Electronically controlled functions are mal-
functioning
Energy surges (e.g. lightning strike) Reset the function concerned
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Constructa CF234653 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Constructa CF234653 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Constructa CF234653

Constructa CF234653 User Manual - German, French - 48 pages

Constructa CF234653 User Manual - Italian - 24 pages

Constructa CF234653 User Manual - Polish - 24 pages

Constructa CF234653 User Manual - Portuguese - 24 pages

Constructa CF234653 User Manual - Swedish - 24 pages

Constructa CF234653 User Manual - Turkish - 24 pages

Constructa CF234653 User Manual - Spanish - 24 pages

Constructa CF234653 User Manual - Norwegian - 24 pages

Constructa CF234653 User Manual - Finnish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info