714959

Constructa CD30645 Manual

25
Zoom out
Zoom in
Previous page
1/56
Next page
25
: Risk of electric shock!
It must always be possible to disconnect the appliance from the
electricity supply. The appliance must only be connected to a
protective contact socket that has been correctly installed. If the
plug is no longer accessible once the appliance has been
installed, or a fixed connection is required, the installation must
have an all-pole isolating switch with a contact gap of at least
3 mm. Only an electrician may install the fixed connection. We
recommend installing a residual-current circuit breaker (RCCB)
in the appliance's power supply circuit.
Preparing the units
■ The fitted unit must be level and have sufficient load-bearing
capacity.
■ The max. weight of the extractor hood is 18 kg.
Appliance dimensions and safety clearances
■ Observe the appliance's dimensions.
■ Comply with the safety clearances.
If the installation instructions for the gas cooking appliances
specify a different distance, the largest distance must always be
provided for.
The fitted unit must be heat-resistant up to 90 °C. The fitted unit
must still be sturdy after the cut-outs have been made.
To install an upper cabinet, this extractor hood must be
provided with the following dimensions:
1. Make the cut-out for the exhaust air pipe. To do this, make an
opening in the ceiling or back wall of the fitted unit with an
additional recess for the power cord.
2. If the cabinet base is present, remove this. Mark the securing
points on the inside of the cabinet and pre-cut the holes
using a piercer. Use the enclosed template to mark the
securing points. ¨
3. Screw in the four enclosed screws for the angle bracket up to
5 mm. ©
Preparing the appliance
A handle strip must be screwed to the filter pull-out. This handle
strip can be one that is provided with the appliance, or one that
is available as an accessory.
1. Use the screws provided to secure the handle strip to the
filter pull-out.
Width 600 mm
Depth Min. 320 mm
Height Min. 390 mm
PP
PP
[
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Constructa CD30645 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Constructa CD30645 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info