8645
14
Zoom out
Zoom in
Previous page
1/47
Next page
Per VC Settings
Virtual Circuit:
Selection Enable or Disable.
Bridge:
Enabling bridge mode will place the unit into Transparent bridge mode (like a Ethernet
ADSL modem) to use this mode you should also set your WAN type to a Bridging option
(e.g RFC1482 Bridge using LLC).
IGMP:
IGMP relay/proxy specification and environment:
Support IGMP proxy/relay function for ADSL modem, based on the following
requirement and case:
On CO side, there must be at least one IGMP querier (router) present. IGMP querier
will send IGMP query packet. The ADSL modem is responsible to relay these IGMP
query to Ethernet.
End-user multicast application device send IGMP report while receiving IGMP query or
being activated by user, the ADSL modem should be responsible to proxy (that is,
change source IP to ADSL modem’s WAN IP) the IGMP report to ADSL WAN side, include
all PVCs. The same case is for IGMP leave packet.
Not necessary to relay multicast routing between two ADSL PVCs or two interfaces in
LAN side.
Special purpose multicast packet (such as RIP 2 packet) should run without
interference.
Encapsulation:
Selection follow as Table-1 Configuration
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Conceptronic ADSLR4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Conceptronic ADSLR4 in the language / languages: English as an attachment in your email.

The manual is 2,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info