802924

Concept VP8337 Manual

25
Zoom out
Zoom in
Previous page
1/55
Next page
ENEN
4948 VP8336 | VP8337 | VP8338 | VP8339VP8336 | VP8337 | VP8338 | VP8339
29VP9181
EN
CLEANING AND REPLACING THE AIR OUTLET FILTER
1.Opentheairoutletgridintheappliance‘srearsection(Fig.5).
2. Removetheairoutletlter.Thistypeofvacuumcleanerisequippedwitha
H.E.P.A.lterintheoutlet,whichiscapableofcatchingevenverynedust
particles.Youcancleanthislterbytappingit,thenbrushingitwithasoft
brush.Afterthisoperationiscomplete,youmaycleanaverydirtylterby
washingandbrushingwithasoftbrushinlukewarmwaterwithnocleaning
agentsadded.Itisimportanttoletthewetpartsdrythoroughly.Awetlter
willbedamagedbyvacuuming!Donotuseahairdryertodryit!
Note: Wet cleaning may cause more wear and tear of the lter and,
consequently,mayshortenitsservicelife.
3. Insertthecleanedornewairoutletlterintotheapplianceandclosetheair
outletgrid.
TROUBLESHOOTING
Problem Cause Solution
Motordoesnotrun.
Pluginsertedintothemainsoutlet
incorrectlyorinsuciently. Checktheplugconnection.
Themainsoutletisnotlive. Checkforvoltage,e.g.byconnecting
anotherappliance.
Motorhasstopped
operating.
Improperorinsucientairow.Motor
overheatingfuseactivated.
Disconnect the cable from the socket.
Checkandreleasetheairsuction
anddischargeholes;checkthelter’s
cleanlinessand/orreplacethedustbag.
Letthevacuumcleanercooldown.
Frontcovercannotbe
closed Dustbaginsertedincorrectly. Checkthedustlterinstallation.
Reducedsuctionpower
Dustbagfullorclogged. Replacethedustbag.
Obstructedlter. Cleanorreplacethelter.
Cloggednozzle,tube,orhose. Checkandcleartheairpassageonthe
suctionanddischargesides.
Vacuumcleanerheats
up Slightheatingofthevacuumcleanerisnormalandcannotbeconsideredafailure.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor lters) Order code sms9000 Priced according to the valid price list
Fabric dust bag, 1 Ord. No. ts9180 Price according to the applicable price list
Motor lter Order code44290910 Price according to the valid price list
H.E.P.A. air outlet lter Order code 44290911 Priced according to the valid price list
(Fig.5)
29
VP8110, VP8111, VP8112
EN
(Fig. 5)
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance‘s rear section (Fig. 5).
2. Remove the air outlet lter. You can clean this lter by tapping it, then brushing it
with a soft brush. After this operation is complete, you may clean a very dirty lter by
washing and brushing with a soft brush in lukewarm water with no cleaning agents
added. It is important to let the wet parts dry thoroughly. A wet lter will be dam-
aged by vacuuming! Do not use a hair dryer to dry it!
Note: Wet cleaning may cause more wear and tear of the lter and, consequently,
may shorten its service life.
3. Insert the cleaned or new air outlet lter into the appliance and close the air outlet
grid.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor lters) Order code sms9000 Priced according to the valid price list
Fabric dust bag, 1 Order code 44291711 Price according to the applicable price list
Motor ler Order code 44291704 Price according to the valid price list
28 VP9181
EN
CHECKING THE DUST COLLECTION BAG FILL
Whenthedustcollectionbagllindicatorturnsredduringoperation,replacethefulldustcollectionbagimmediately.
Ifthedustcollectionbagllindicatorisstillredafterthebaghasbeenreplaced,thismaybeduetoseveralcauses:
-someoftheairpassages(hoses,telescopictube,suctioninlet,brushadapter,orotheradapters)areobstructed;
-themotorlterisdirty;
-theairoutletlterisdirty.
Checkfor eachofthepossiblecausesaboveandeliminatetheproblembeforeyou startvacuuming.If thecauseofthe
problemcannotbeidentied,handover theproductto thenearestservicecentre.Neverusethevacuumcleanerifthe
baglevelindicatoriscompletelyredduringoperation.Themotorcouldbedamagedirreparably
CLEANING AND MAINTENANCE
You may clean the accessories and the appliance with a wet cloth. Never immerse
the appliance in water! Do not use any aggressive substances for cleaning, such as
solvents or abrasives!
REPLACING THE DUST COLLECTION BAG
1. Unplug the product from the mains. Disconnect the hose from the suction inlet
and open the appliance cover.
2. Push the ap on the dust retention bag holder; remove the used dust retention
bag (Fig. 3). Dispose of a paper or SMS dust collection bag. Be careful not to tear
the bag when handling. If the bag is made of fabric, empty it and close it
carefully - it can be used repeatedly.
3. Insert a new or empty dust retention bag by tting the plate in the bag holder. The
bag opening must be aligned with the hose hole in the appliance cover.
4. Never use the vacuum cleaner without the dust bag installed! If you forget to
insert the dust retention bag or you insert it incorrectly, the appliance‘s motor
may become damaged.
5. Close the cover. Press until you hear a click.
REPLACING FILTERS
• The lters should be cleaned or replaced when they are visibly dirty, or if the
appliance‘s suction power is reduced. Always check the lters after using the
appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly installed
lters.
• Before replacing the lters, disconnect the appliance from the electrical socket.
• You can buy suitable types of lters from your dealer, or you can order them from
the manufacturer.
CLEANING AND REPLACEMENT OF THE MOTOR FILTER
1. Disconnect the exible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the motor lter
more easily.
3. Remove the motor lter (Fig. 4). You can clean the lter by tapping it. If the lter is
heavily soiled, you may wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor lter into the appliance and close the cover.
(Fig.3)
(Fig.4)
28 VP8110, VP8111, VP8112
EN
(Fig. 3)
(Fig. 4)
37
EN
VP 8336
30 VP9181
EN
ENVIRONMENTAL PROTECTION
- Packagingmaterialsandobsoleteappliancesshouldberecycled.
- Thetransportboxmaybedisposedofassortedwaste.
- Polyethylenebagsshallbehandedoverforrecycling.
Recycling the product at the end of its service life
The symbolaxedto theproductoritspackagingindicatesthattheproductmay notbedisposedofas
householdwaste.It mustbetakento thecollectionfacilityauthorizedfor recyclingelectricandelectronic
waste. By ensuring that this product is disposed of correctly, you will help prevent potential negative
consequencesfor theenvironmentandhumanhealth,whichcouldotherwisebecausedby inappropriate
wastehandlingofthisproduct.For moredetailedinformationaboutthetreatment,recovery andrecycling
ofthisproduct,pleasecontactyourlocalcityoce,yourhouseholdwastedisposalserviceortheshop
whereyoupurchasedtheproduct.
SERVICE
Anylargermaintenanceorrepairsrequiringinterventionintotheinternalpartsoftheproductshallonlybeperformed
byanauthorizedservice
30 VP8110, VP8111, VP8112
EN
Recycling the product at the end of its service life
The symbol axed to the product or its packaging indicates that the product may not be
disposed of as household waste. It must be taken to the collection facility authorized for
recycling electric and electronic waste. By ensuring that this product is disposed of correctly,
you will help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. For more
detailed information about the treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
This product meets all the basic EU regulation requirements that relate to it.
38
Changes to the text, design and technical specifications may occur without prior notice and we reserve the
right to make these changes.
EN
VP 8336
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Concept VP8337 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Concept VP8337 in the language / languages: English, German, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 6.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info