521985
14
Zoom out
Zoom in
Previous page
1/24
Next page
CSB200 Class B AIS
R2.0 27
'Update' button should be clicked to send new settings to
the AIS transponder.
Alarm output options
By default the AIS transponder will output the status of all alarms every
minute using AIALR sentences. The unit can be optionally configured to
only output active alarms using the radio buttons. The 'Update' button
should be clicked to send new settings to the AIS transponder.
CSB200 Class B AIS
R2.0 28
USING THE CSB200
Switching on
When the 12VDC supply is switched on the green ON LED will light and
the other six LED’s visible on the front panel of the unit will illuminate
twice for a period of one second on each illumination. The Status, TX Off
and TX LEDs will then go out. The green RX LED will flash when it is
receiving data from other AIS units.
When the internal GPS is locked the yellow LED will go out and the
green Status Led will light; note that this process may take several
minutes depending on the switch-on state of the GPS receiver. The red
TX LED will flash momentarily every time the unit transmits.
NOTE If the unit has not been programmed with an MMSI number the
green RX, yellow Timeout and red Error LED will remain on.
Warning and Fault States
If the unit has not been able to transmit a position report during the last
expected two reporting intervals (i.e. the nominal reporting interval cannot
be maintained for operational reasons such as a Message 23 quiet
period, high channel load conditions, etc) the yellow LED will illuminate.
This is a warning condition only and indicates that your vessels
position is not currently being reported to other vessels. Reception of
other vessel AIS information by the CSB200 is not affected. When the
unit is able to commence reporting the yellow LED goes out.
If a fault occurs the red Error LED will illuminate. This may illuminate
briefly if the power supply is interrupted or if the VHF antenna
characteristics are briefly affected.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Comar CSB200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Comar CSB200 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info