669020

Cola Emily Manual

8
Zoom out
Zoom in
Previous page
1/12
Next page
7 Emily
Before connecting stove to an existing chimney, in addition to complying with that described above, make sure
there are no openings or cracks where air could enter and cause a temperature decrease affecting the draught.
Also make sure there are no
hindrances caused by foreign bodies
or a build-up of soot.
The first connection section leaving
the stove should be vertical, whereas
the flue connection to the chimney
(which goes to the chimney cap)
must only enter by a few cm, so as
not to reduce the cross section of the
flue.
If the flue is not perpendicular to the
chimney it is advisable to make the
connection
with special steel fittings that
allow a maximum slope of 45°.
If the walls and ceiling are made
of flammable materials, the parts in contact with the flue must be suitably insulated. All connection joints must
be carefully sealed, in particular where the connection enters the flue.
If there are several heating stoves in the same home, each must have its own flue. It is inadvisable to make
openings in the flue for other appliances, since the draught could be negatively affected.
According to Standard UNI 7429, the chimney cap must meet several requirements; above all, it must have a
useful outlet cross section at least double that of the flue. It is also advisable to install an "antiwind" cap that
guarantees fume exhaust even in the presence of strong horizontal winds.
NO SI SI
SI NO
Fig. 4 Chimney caps
3 – STOVE USE
3.1 Introduction
Never leave children unsupervised in the vicinity of the stove; the risk of burns caused by the hot parts is very
high.
Make sure to carefully observe the following rules:
- never use the stove with the door open;
- do not store firelighters or easily flammable materials near the stove;
- do not move or lift the stove using the handles.
3.2 Combustion air adjustment
Primary air:
the primary air is adjusted using the manual revolving controls located on the firebox door, and feeds the fire
through the grate.
Secondary air:
the secondary air enters the stove by means of the sliding control located above the firebox door.
Optimum combustion conditions are obtained when, on loading wood, the air necessary for combustion enters
through the grate, whereas the secondary air, entering through the control, enables the completion of
combustion in the upper part of the firebox.
3.3 Startup
When lighting the stove the first time, bad odours may be created, therefore air the room thoroughly. With first
lighting the heating stove must operate for many hours with a low flame (primary air control open 30%).
The heat can then be increased a little at a time, so that the stove expands slowly and the paint and putty dry.
NO
NO
YES
M AX 45°
Fig. 3 stove
-
chimney connection
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cola Emily at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cola Emily in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info