Manual Cointra Eccotemp CE-L10 (page 17 of 90) (English, German, Dutch, French)

635865

Zoom out

Zoom in

1/90

NOTE: Before attempting to remove the cover, call technical

support found on page 1

e. A wire has become disconnected inside the unit during

shipping. Make sure the gas is OFF. The front cover is held by six

screws, four on top, two on bottom. The knobs pull off. All the

wiring is done with push together plastic connectors. They are all

visible without further dismantling of the unit. It should be obvious

when a wire has become disconnected.

f. It is possible that some debris or epoxy might have entered the

water regulator. Check to see if the filter screen on the water inlet

is clear of debris. You can also reverse the hookup by taking your

water source and hooking it up to the water outlet side and back

flushing the system.

g. Propane gas cylinders sometimes are contaminated with air,

especially new tanks upon their first filling. Cycle the unit on and

off by using the shower head switch several times (5) to purge the

air from the gas.

Should a unit fail to light or stay lit after 10 cycles, Call

technical support found on page 1

Units starts, then shuts off:

a. The unit requires a minimum of about 0.5 gallons per minute (2

liters) and a minimum of about 20 PSI / 1.38 bar* Note, water

pressure is at the lower end of operating parameters. You will

need a sustained water pressure of approximately 40-60 PSI / 2.7-

4.1 bar for adequate use if you are using a 12/18/120/240 volt

pump. See ADJUSTMENT in previous section above.

b. High wind

c. Out of, or low on gas. Propane gas cylinders sometimes are

contaminated with air, especially new tanks upon their first filling.

Cycle the unit on and off by using the shower head switch several

times (5) to purge the air from the gas.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cointra Eccotemp CE-L10 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cointra Eccotemp CE-L10 Manual

Product: