634451

Cobra LS6000 Manual

9
Zoom out
Zoom in
Previous page
1/14
Next page
9
Operation
Two-hand operation
Never operate the log splitter with two people.
Never block the control handles (clamping claws).
1. Press the green switch on the electric motor. Wait a few
moments until the motor has reached its operating
revolut
ions and the requir
ed pressure has
been built up in
the hydraulic pump.
L
At temperatures below –5° C, let the log splitter run
for at least 15 min. in neutral to heat up the oil.
2. Place the log on the
log splitter table.
L Only split the logs in the direction of the wood fibres.
Hold the log tight with the clamping claws.
3. Press both operating handles down simultaneously:
Î The s
plitting blade falls down and splits t
he log.
4. Release the two control handles, the splitting blade
returns to its initial position.
L
If you only release one control handle, then the
splitting blade r
emains wher
e it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum
dimensions. Ensure also that the logs are cut straight and
square.
Place the log properly on the log splitter, so as not to cause
any risk of stumbling or falling to the operator.
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be
increased by shortening the
return of the splitting cutter.
1. Place the log on the splitting table and press the
two control handles to bring the splitting blade
down to approx. 2 cm above the log.
2. Release one control handle so that the blade
stays in this position.
3. Switch the machine off and disconnect the power.
4. Release the second control handle.
5. Shorten the re-
turn path
at the
rod fitted to the
side by fixing the
holding screw at
the necessary
height.
Adjusting the table height
Upper table plate
position for logs
up to 540 mm
Middle table
plate pos
ition for
logs up to 750
mm
Lower t
able plate
pos
ition for logs
up to
1040 mm
Holding
screw
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra LS6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra LS6000 in the language / languages: English as an attachment in your email.

The manual is 4,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info