634451
8
Zoom out
Zoom in
Previous page
1/14
Next page
8
Venting
Vent the hydraulic system before putting the log splitter
into operation.
! Unscrew venting screw by several turns so that air
may escape from the oil tank.
! Leave the screw open during operation.
! Close the venting screw before moving the log
splitter, as otherwise oil will leak at this point.
oil cap
L
If the hydraulic system is not vented, the trapped air will
damage the seals and cause permanent damage to the log
splitter.
L
Mains connection
Compare the voltage given on the machine model plate
e.g. 230 V with the mains voltage and connect the
machine to the relevant and properly earthed plug.
Only use connection cables with sufficient cross-
sections.
Connect the machine via a 30 mA fault current safety
switch.
L
Fuse protection
230 V ~ ÎÎ 13 A time-lag
L
Switching on / off
Prior to every use, check the function of the
disconnection mechanism (by switching on and off).
Do not use any device where the switch can not be
switch
ed on and off. Damaged switches must be
repa
ired or replaced immediately by the customer
service.
Switching on
Press the green button.
Switching off
Press the red button.
L
Lock in case of power (zero-voltage
initiator)
The equipment will switch off automatically if there is a power
cut. Repress the green button to switch it on again.
L
Hydraulics
Never operate the machine in the event of any possible
danger from hydraulic fluid.
Ensure that the machine and working area are clean
and
free of oil.
Danger of slippage or fire!
Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see “Care and
maintenance”).
Capacity: approx. 4.0 litres
W
W
o
o
r
r
k
k
i
i
n
n
g
g
w
w
i
i
t
t
h
h
t
t
h
h
e
e
l
l
o
o
g
g
s
s
p
p
l
l
i
i
t
t
t
t
e
e
r
r
Additional SAFETY INSTRUCTIONS
The log splitter may only be operated by a single person.
The mac
hine may only be operated by persons over t
he
age
of 18 years, and who have read and underst
ood
these operating instructions.
Wear protective equipment (safety goggles/mask, gloves,
safety shoes) to protect yourself from possible injur
y.
Never try to split logs containing nails, wire or other
similar objects.
Already split wood and wood chips
create a dangerous
working area. The operator may stumble, slip or fall.
Always keep the working area neat and tidy.
Never place the hands on or near any moving parts of the
mac
hine when it is switched on. Maintain a safe distanc
e
from the log, the ram and the wedge in order to protect
your hands from injury.
The machine should only be used for splitting logs with a
maximum length of 1050 mm.
L Check before splitting if the splitting column has
been sufficiently lubricated to allow its trouble-fr
ee
retraction and extension.
What type of logs can I split?
Size of logs
Length: max. 1050 mm
Diameter: min. 120 – max. 350 mm
The log diameter is a recommended guideline figure,
because:
thin logs ca
n be difficult to split if they contain knots or if
the fibres are too strong.
Do not try to split green logs. Dry logs are much easier to
split, and do not cause jams as often as green (damp) wood.
Hardwood tend to bursting: Exercise utmost caution!
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cobra LS6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cobra LS6000 in the language / languages: English as an attachment in your email.

The manual is 4,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info