Identify and take note of the TV code which you have
searched for following the code noting procedure
(see “PROGRAMMED CODE NOTING” section).
1. Make sure that your TV is
ON.
2. In the Code Book, look for
your TV brand and make a
note of the corresponding
TV code indicated to the
side (e.g. Philips 0025). If
your TV brand is not
listed, apply the global
search described in
paragraph B.
3. Hold down the and
number keys together
until the light indicator at
the top starts to flash
indicating that the remote
control is programming.
4. Release the keys, Within
15 seconds, enter the
brand code previously
identified (e.g. 0025). The
light indicator flashes
more quickly to indicate
that the remote control is
ready for the search.
5. Point the remote control
at the TV. Press and
release the key slowly
several times. Stop when
your TV goes OFF (you
may have to press the
key dozens of times).
6. When your TV is off, press
the key to confirm.
Three long flashes
indicate that the operation
has been completed
correctly.
Additional check
Check that some of the
other functions used on your
original remote control are
working correctly. If the
commands function
incorrectly or erratically, you
have probably entered a
code for a similar but
different remote control. In
this case, repeat the search
procedure from point 3.
BRAND SEARCH PROGRAMMING MODE
A
SET-UP
Read these instructions carefully before programming
your remote control!
To command your appliances, you must program your
Easytel one 100 as described in
paragraphs
A or B below.
Visit out Internet site www.cme.it for interactive instructions
for easy and fast remote control programming.
NOTE: during the search operation, the light indicator flashes
more quickly. The light indicator stops flashing and the
remote control leaves the programming mode in the following
cases:
• if no keys are pressed for 12 seconds
• if the code search list is completed. In this case, switch to
programming mode B
7
