To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Flick the switch back to its center position. The LED will turn off to confirm that the
system is now in its normal operating mode.
Setting your own secret valet code
Since all Concept Series systems have the same factory-set code, it is highly
advisable that you set your own valet code. You may choose any 1-, 2-, or 3-digit
code that does not have any zeros. You can also change your valet code whenever
you want. Simply write down the 1-to-3 digit code you wish to use (remember, no
zeros in the code), then refer to the User-selectable features section on pages 16-20.
Example
Let’s say you want to set your valet code to 31. To do so, you would do the following:
1. From the Table of user-selectable features on pages 19 and 20, you would note that
the “set a new secret valet code” feature is in column 3, row 6.
2. Enter program mode by turning on the ignition, entering your current valet code, then
pressing the PlainView switch to its momentary side for 3 seconds until you hear a
chirp.
3. Select column 3 by moving the switch between latched and center 3 times, i.e.:
latched, center, latched, center, latched, center. After a brief pause, you will hear 3
chirps to confirm that you have selected feature column 3.
4. Select row 6 by pressing and releasing the momentary side of the switch 6 times. To
help you count, you will hear a chirp each time you press the momentary side.
5. Immediately flip the switch to the latched position.
6. Enter you new code. To enter 31 as your new code, you would press the switch in
this manner: momentary, momentary, momentary, latched (you’ll hear 3 chirps to
confirm the first digit), momentary, latched (1 chirp to confirm the second digit),
center.
7. Wait 3 seconds until you hear 2 chirps, indicating the new code has been accepted.
8. Turn off the ignition to exit program mode (you’ll hear a 3-chirp confirmation).
9. VERY IMPORTANT: You must immediately test your new secret valet code:
Turn on the ignition, enter your new code, then flip the switch to its latched position.
The LED will illuminate. If it does not, the new code you programmed and the one you
just entered do not match. In such a case, the system will revert to the previous code.
Keyless entry in valet mode
Even if valet mode is enabled, you can still remotely control the convenience
features. For instance, simply press button 1 (channel 1) as if you were disarming
and the doors will unlock (indicated by one parking light flash) and the interior lights
will turn on. Press button 1 again and the doors lock (confirmed by two flashes).
You can also use the other channels to activate options such as a remote trunk
release or remote engine starting.
11
