462050

ClearOne PRO 8i Manual

228
Zoom out
Zoom in
Previous page
1/345
Next page
223
continue using the specified settings until the Signal Timeout is reached, or the Signal On button is
pressed again, whichever occurs first.
Tone Frequency Settings
Configure Frequency settings for tone tests as follows:
Select a tone frequency using the 1. Frequency slider, or enter a frequency in the entry box.
Alternatively use the 2. Auto Sweep button to sweep a range of frequencies using the Begin Frequency, End
Frequency, Increment, and Rate settings. Select the Repeat checkbox if you want the sweep to continue
in cycles.
NOTE: Use auto sweep to test the frequency response of a room and speakers, and to identify
distortion or rattles produced by the speakers or speaker housings. Auto sweep moves
the frequency of the signal generator from a low frequency to a high frequency at the
specified rate. The Frequency slide control and readout reflect progress while the sweep
is in progress. Sweep range is 20Hz—20kHz; increment range is 1Hz—20kHz, and the
rate range is 10ms—2000ms. The default rate is 100ms.
3. Press the Signal On button to generate the tone test signal, or press the Auto Sweep button to initiate an
auto sweep.
System Checks Tab
System Checks enable you to test network connections, telephone connections, microphones, and output
channels for all units in a site. Running system checks can help identify component failures within the system using
the tests you select on the System Check Config tab (described in the next section).
The test LEDs indicate test results as follows:
Red• = Test fails
Yellow• = Test not enabled in System Check Config
Green• = Test passes
… 228 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ClearOne PRO 8i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ClearOne PRO 8i in the language / languages: English as an attachment in your email.

The manual is 10,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info