462047
169
Zoom out
Zoom in
Previous page
1/345
Next page
164
CONTROL TAB
The Control Tab allows you to configure pin assignments for the user-definable pins on Control/Status Port A and
Control/Status Port B.
All models implement control/status using DB-25 pin ports on the back panel, and GPIO (General Purpose Input
Output) with active low/pull to ground inputs and open collector outputs. For details, refer to Appendix B and the
Control/Status Ports section of Appendix D: Specifications.
The control ports enable external devices to access the Converge/Converge Pro serial command set, including
common functions such as volume control, muting, room combining, and preset changes. All devices connected
via the E-bus can be controlled from a single control/status port on any of the devices.
Accessing the Control Tab
To access command control, press the Control Tab on the Tab Bar in Console.
The Control tab of the Console main screen shows a graphical representation of Control/Status Port A. The pins
numbered in blue are user-definable command pins; the pins numbered in green are status pins. Control interface
functionality and pin programming are explained in the following sections.
User-Definable Pins
The user-definable pins provide control via contact closure, and status via open collector functions in the unit. There
are two user-definable pins on the B port of every unit. The number of user-definable pins on the A port varies by
model, as summarized in the following table:
Model User-Definable Pins
Control/Status Port A
User-Definable Pins
Control/Status Port B
880 16 2
880T 16 2
880TA 16 2
840T 20 2
169


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ClearOne PRO 880T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ClearOne PRO 880T in the language / languages: English as an attachment in your email.

The manual is 10,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info