646280
26
Zoom out
Zoom in
Previous page
1/64
Next page
26
not pull out the cable with force up to its maximum length (not further than the red
marking on the cable) in order to prevent damage!
Always switch the device off rst and remove the mains plug from the mains socket
before replacing a nozzle or attaching or removing any accessories.
On no account should the device be used to suck up the following:
Liquids or wet substances (e.g. wet carpet shampoo)
Glowing ash, cigarette ends, matches, etc.
–In ammable or explosive substances
Very ne dust (e.g. concrete dust), ash or toner
Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are attached correctly to the device (see the „As-
sembly“ chapter).
2. Pull the mains cable out of the unit as far as you require, ideally up to the yellow
marking, but not further than the red marking on the cable!
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
4. Press the
On/Off switch down to switch on the vacuum cleaner. The On / Off
switch can also be turned to adjust the suction strength individually.
5. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
6. Press the
On/Off switch down again after you have nished vacuum cleaning to
switch off the vacuum cleaner.
7. Pull the mains plug out of the socket, hold the mains cable rmly and using your foot,
depress the
button to retract the cable. Holding the mains cable prevents any
„whiplash“ effect of the cable, e.g. against your legs.
8. Once you have used the oor nozzle, hook it into the bracket on the back of the
device.
9. To ensure optimum performance of the device, you should empty the dust container
and clean all dust lters regularly (see the „Cleaning the Device“ chapter) after every
use.
Tip: The handle is equipped with an exhaust air
valve. Open this valve (by sliding the cover) to
reduce the suction force when cleaning upholstery
or rugs or light, movable objects.
Normally the exhaust air valve should be closed to
prevent the unnecessary reduction of the suction
force.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx Z 08864 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx Z 08864 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info