650347
34
Zoom out
Zoom in
Previous page
1/88
Next page
EN 34
Discharge the rechargeable battery every few months and then
recharge it. To discharge the rechargeable battery, use the device with
the charging station disconnected from the mains so that it runs out of
power. Then recharge the rechargeable battery.
You can determine the charge level of the rechargeable battery using the
charge status indicator (19) on the display (7): If the indicator is ashing, the
rechargeable battery is still charging; if it is no longer ashing and the display
turns off on its own, the device is ready for use.
Before rst use or if the device has not been used for a prolonged period of
time, it will take approximately 8 to 9 hours for the empty rechargeable battery
to recharge; subsequent charge times will then range from approx. 4 to 6 hours.
The rechargeable battery will reach its full charge capacity after it has been fully
discharged and recharged completely two to three times. There are two methods
for charging it: directly with the mains adapter or via the charging station.
If the rechargeable battery is completely empty and the device is unable to
travel to the charging station, it must be placed on the charging station or
charged directly via the mains adapter.
Charging directly with the mains adapter
1. Make sure that the device is in standby mode (not in vacuuming mode).
2. Connect the mains adapter cord directly to the device.
3. Insert the mains plug of the mains adapter in an easily accessible socket.
4. The charging process will then begin.
5. Disconnect the device from the power supply after approx. 4 – 6 hours. If
three bars appear on the charge level indicator after it is disconnected, then
the rechargeable battery has been fully charged.
The display will not indicate that the device is being charged when
charged with the mains adapter.
Charging via the charging station
Once the charge level of the robotic vacuum cleaners rechargeable battery is
low, it will travel to the charging station where the rechargeable battery will be
automatically recharged. For this, the charging station must be connected to the
mains (see chapter “Charging station”).
If the device fails to locate the charging station because e.g. the room is too large
and it comes to a stop, you should “give it helping hand”. Use the directional
buttons on the remote control (D) to steer the device towards the charging
station or place it directly on the charging station.
While the device is vacuuming, leave the charging station connected to the
mains so that it can automatically dock and recharge for the next cleaning
cycle. To ensure that the device is properly positioned on the charging
contacts, check whether the indicator light on the charging station is red
after the device has docked.
06025_DE-GB-FR-NL_A5_V5.indb 3406025_DE-GB-FR-NL_A5_V5.indb 34 24.04.2015 10:12:2424.04.2015 10:12:24
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx Z 06025 - VR-101A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx Z 06025 - VR-101A in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info