703408
21
Zoom out
Zoom in
Previous page
1/44
Next page
21 EN
Wide-apart buttons may result in the button strip crimping slightly during pressing.
Here it is advisable to smooth down the button strip again by hand immediately after
the pressing process.
In the case of trousers with a very small waist it may not be possible to pull them over
the attachment when it has already been tted. In this case you proceed as follows:
push the nylon balloon (12) upwards slightly, to enable access to the rods (13),
remove one of the two rods from the Y tube once more (11),
draw the trousers over the two rods,
now replace the rods in the Y tube and
draw the nylon balloon over the mounting ange on the main device again.
After the drying / pressing process any creases need to be ironed out using a normal
iron.
Cleaning and Storage
PLEASE NOTE!
Do not use any corrosive or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
Clean the device and the nylon balloons if necessary with a slightly damp cloth and a
little mild detergent if required. Then wipe down fully with a dry cloth.
Allow all parts to dry completely before you put them away.
Store the device in a clean, dry place that is protected from sunlight and is not acces-
sible to children and animals.
Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair a defective
electrical device yourself!
Problem Possible cause / solution
The device does not
work. The LEDs do
not light up.
Is the mains plug inserted in the plug socket correctly? Cor-
rect the t of the mains plug.
Is the plug socket defective? Try another plug socket.
Check the fuse of the mains connection.
Is the device switched on? Set the timer (7) to a time.
Unusual noises
Are the ventilation slots (6) covered up or blocked? Free up
the ventilation slots.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cleanmaxx EL17001-00100 - Z07252 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cleanmaxx EL17001-00100 - Z07252 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info