Manual Clatronic km 2717 (page 25 of 42) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish)

380486

Zoom out

Zoom in

1/42

DANSK

ENGLISH

General Safety Instructions

Read the operating instructions carefully before putting the

appliance into operation and keep the instructions including the

warranty, the receipt and, if possible, the box with the internal

packing.

• The appliance is designed exclusively for private use

and for the envisaged purpose. This appliance is not ﬁ t

for commercial use. Do not use it outdoors (except if it is

designed to be used outdoors). Keep it away from sources

of heat, direct sunlight, humidity (never dip it into any liquid)

and sharp edges. Do not use the appliance with wet hands.

If the appliance is humid or wet, unplug it immediately. Do

not put it in water.

• When cleaning or putting it away, switch off the appliance

and always pull out the plug from the socket (pull on the

plug, not the cable) if the appliance is not being used and

remove the attached accessories.

• Do not operate the machine without supervision. If you

should leave the workplace, always switch the machine off

or remove the plug from the socket (pull the plug itself, not

the lead).

• Check the appliance and the cable for damage on a regular

basis. Do not use the appliance if it is damaged.

• Do not try to repair the appliance on your own. Always

contact an authorized technician. To avoid the exposure

to danger, always have a faulty cable be replaced only by

the manufacturer, by our customer service or by a qualiﬁ ed

person and with a cable of the same type.

• Use only original spare parts.

• Pay careful attention to the following “Special Safety Instruc-

tions“.

Children

• In order to ensure your children‘s safety, please keep all

packaging (plastic bags, boxes, polystyrene etc.) out of their

reach.

Caution! Do not allow small children to play with the foil as

there is a danger of suffocation!

• To protect children from the dangers posed by electrical

appliances, make sure that the cable is hanging low and that

children do not have access to the appliance.

Special safety instructions

• WARNING: The cutter and grater attachments, the chopper

and the French fry slicer have extremely sharp cutting

and grating surfaces and edges! When removing the

attachments from the bowl and container you will come into

contact with this accessory. Handle this accessory with care

to avoid injuries.

• Before changing the attachments, the appliance must be

disconnected from the mains!

• Do not reach into the mixer vessel as the underlying blade

may cause injuries under certain circumstances!

• The appliance is equipped with a safety switch. Do not use

the appliance in case of malfunctions or if the safety switch

has been tampered with!

• Do not remove the lid during use.

• Switch on the appliance only once the presser in the

opening of the lid is inserted.

• Use only the supplied presser to press the food. Do not

use your ﬁ ngers, forks or other objects to avoid injuries or

damage.

• Do not use the appliance when empty.

• Do not carry or lift the appliance during use. Always switch

it off ﬁ rst and pull out the plug. Carry the appliance always

with both hands!

• Clean the appliance only as described in „Cleaning“.

Overview of the Components

1 Utensil switch

2 Kitchen machine, basis appliance

3 Mixer vessel

4 Mixer vessel lid with ﬁ lling slot

5 Filling slot seal

6 Disk for chips

7 Grating disk

8 Mixing bowl lid

9 Mixing bowl driveshaft

10 Mixing bowl

11 Grater utensil

12 Cutting utensil

13 Filler tube

14 Utensil holder

15 Metal blade

16 Plastic blade

17 Filler

18 Spatula

19 Mixer lid

20 Accessory drawer

21 Locating pin

Operation of machine

Assembly of mixing bowl and lid

Please all parts before using for the ﬁ rst time (see „Cleaning“).

1. Place the bowl (10) on the base (2) in such a way that the

left mark on the bowl is pointing to the lower

▲

mark on

the base. Then turn the bowl clockwise until you hear it lock

into place. The right mark of the bowl is now pointing to

the

▲

mark on the base.

2. Place a tool (14, 15, 16) on the drive axle.

3. Press the equipment you wish to use (grating or cutting

attachments) - to be found in the accessories drawer (20)

- as far as it will go on to the device holder (14).

4. When the tool holder (14) is selected the guide mandrel (21)

must be attached. The metal point faces upwards.

5. Place the lid on the bowl (8) so that the left arrow on the

lid is in line with the

▲

mark on the bowl. The metal tip of

the locating pin (21) has to engage into its bearing in the lid.

Then turn the lid clockwise until the protruding section on

the lid is heard to lock into place in the safety lock opening

on the base of the machine. Now the right mark on the lid

is pointing to the

▲

mark on the bowl. To remove the lid,

turn it in an anticlockwise direction.

05-KM 2717 N4 25 02.05.2006, 11:58:01 Uhr

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic km 2717 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Clatronic km 2717 Manual

Product: