653878

Clatronic EKI 3569 Manual

43
Zoom out
Zoom in
Previous page
1/82
Next page
43
NOTE:
Production residue or dust may have collected on the appli-
ance. We recommend cleaning the appliance according to
chapter “Cleaning”.
Location of Controls
1 Air outlet
2 Mains plug
3 Housing
4 Glass ceramic surface
5 Indicator lights POWER / TEMP. / TIME / ON/OFF
6
ON/OFF (on/standby button)
7
selector button
8 Setting the power / temperature / turn-off time
increase
reduce
9 Display
10 Direct selection of the highest or lowest power setting
highest
lowest
11 Air inlet
General information
Cooking with induction technology
When cooking with induction technology, heat is only generated
by means of magnetic power, if a pot or pan with a magne-
tisable base is placed on a switched-on cooking zone. The
induction cooker heats only the base of the cooking utensils
used, not the cooking zone itself. Under the glass-ceramics
surface, the induction coil is located. If the coil is supplied with
electrical power a magnetic eld develops generating whirls in
the pot’s base. This results in the heating of the base material.
The induction process saves energy as heat is solely produced
where it is needed.
What cooking utensils may I use?
For induction cooking plates cookware made from magneti-
sable material is needed. Today, cooking utensils appropriate
for induction cooking usually bear a note saying “Suitable for
induction hob” or similar.
But principally you may use any iron-based cooking utensils; to
nd out whether a pot or pan is suitable, i.e., magnetisable just
try the following:
Position the cookware. If several warning signals sound and if
the message “E0” appears, the cookware is unsuitable.
NOTE:
For safety reasons, the appliance will switch to standby mode
after about 30 seconds.
Cooking utensils made of the following materials are not
suitable for induction hobs:
Clay, glass or aluminium.
Do not use the following types of pots :
Pots with
bended (convex/
parabolic)
bases.
Pots with a base
diameter of less
than 12 cm.
Pots standing
on feet.
Electrical Connection
Connected load/wattage
The hob can take up an overall load of 2000 W. Because of
this high connected load it is recommended to use a separate
connection protected over a 16 A safety switch.
CAUTION: OVERLOAD!
Do not use extension cables or multiple sockets as the power
consumption of this device is too high for these.
Connection
• Before inserting the mains plug into the socket check
whether the voltage which you intend to use corre-
sponds to that of the machine. Please see the label on
the machine for details.
• Only connect the machine to a correctly installed
safety socket.
Operation
• The appliance has a ne sensor. A light touch of the control
panel with the nger is sufcient. Use the nger, not the tip
of the nger.
• Each registered touch is conrmed by a beep.
• In the event that the appliance does not react when you
press the buttons, clean the control panel with a soft, dry
cloth. Even a thin lm of water can make the operation
difcult.
• Ensure that the control panel is always clean and dry and
that it is not covered by objects of any kind.
Standby mode
After you have connected the device’s plug to the mains supply,
the hub is in standby mode. A signal will sound.
• Put a suitable pot on the cooking zone.
• Press the ON/OFF button to start cooking. The indicator
light above the ON/OFF button lights up. The indicator light
for POWER above the SELECT button will ash.
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic EKI 3569 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic EKI 3569 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 6,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info