Manual Clatronic EKI 3569 (page 44 of 82) (English, German, Dutch, French, Italian, Polish, Spanish)

653878

Zoom out

Zoom in

1/82

NOTE:

You must now press the SELECT button within

60 seconds, or the hotplate will switch back to the operat-

ing mode of standby.

Selecting performance, shut-off time or temperature as the

function.

Press the SELECT button to select the control by power, shut-

off time or temperature. The indicator lights POWER, TEMP.

and TIME will show the selection.

Selecting the power or temperature of the hotplate

• Use the UP or DOWN buttons to select one of 10 power

settings between 200 and 2000 W, or one of 10 tempera-

ture settings between 60°C und 240°C.

• The MAX or MIN buttons can be used to directly select

the highest or the lowest power setting and temperature

setting. The maximum or minimum power setting will

appear on the display.

NOTE:

• The hotplate will always start at the sixth power set-

ting with a temperature of 180°C or with 1200 W.

• The display shows the selected setting. The

respective pilot lamp above the SELECT button will

also light up.

• Please observe that the cooking behavior in the pots

differs. It depends on the nature and the quality of the

cooking vessels.

Enter Off Time

1. Turn the appliance on and select any range or temperature.

2. Press the SELECT button to select the control after the

shut-off time. The display will show “0”. The indicator light

TIME above the SELECT button will ash.

3. Set a turn-off time between 5 and 180 minutes by using the

UP or the DOWN button.

NOTE:

• Press the UP or DOWN buttons to set the time in

increments of 5 minutes. The display will show the

desired setting.

• Once you have set a time, the display will remain

for a few seconds. The remaining time and the

function that you have chosen beforehand are then

shown alternately.

• You may change the previous turn-off time at any

time. The other settings (POWER and TEMP.) will

remain.

• After the set time has elapsed, the cooking time will

automatically be turned off and a beep will sound. The

appliance is in standby mode again.

• In order to cancel the shut-off time beforehand, set

the time to “0”. You may also turn the appliance off

directly with the ON/OFF button.

Child safety

To safeguard against unwanted use, the appliance is equipped

with a disable function.

• In order to activate the child lock, press the UP and DOWN

buttons simultaneously.The display will show “L”.

• Press the UP and DOWN buttons again at the same time

to cancel the disable function.

NOTE:

When the child lock is active, all the buttons except for

ON/OFF are locked. The appliance can only be operated

again after unlocking it.

Automatic shut-off

The hot plate turns off automatically after 120 minutes, if no

input was given over the operator control panel during this time.

This switching serves as security for you.

Switching off

1. Press the ON/OFF button.

NOTE:

• The hot plate is reset from its operational state to

standby mode. The fan may continue to run for a

period of time.

• The indicator lights will go out.

2. Pull the plug.

3. Let the device cool down, before you put it away.

Pan recognition

The device has a pot recognition function. It gives several

warnings to indicate that the cookware has been removed. The

message “E0” appears on the display. For safety reasons, the

appliance will switch to standby mode after about 30 seconds.

The fan may continue running.

In this context, please pay attention to the following:

WARNING:

After use, the hot plate is to be switched off by means of its

regulation and control devices ON/OFF button and not just by

pan recognition.

WARNING: Hazard of burns!

Because of the heat radiated during cooking, dangerously

high temperatures may occur at the cooking zone after the

cooking cycle.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic EKI 3569 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 6,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Clatronic EKI 3569 Manual

Product: