686431

Clatronic BZ 3740 Manual

50
Zoom out
Zoom in
Previous page
1/78
Next page
BZ3740_IM 07.03.19
50
Problem Possible cause Solution
No beer is dispensed. The 5 litre party keg is empty or there is not a
5 litre party keg in the beer dispenser.
Place a new 5 litre party keg in the dispenser.
The CO
2
cartridge is empty. Change the CO
2
cartridge.
The keg tap is not tted.
The keg is not correctly tapped.
Attach the dispensing unit to the keg by using
the keg tap. Tap the keg correctly.
The tap handle is not correctly installed. Install the tap handle correctly.
Too much foam is
produced when
dispensing.
The 5 litre party keg is not cold enough. Cool the 5 litre party keg longer.
The 5 litre party keg was shaken. Allow the 5 litre part keg to stand in the beer
dispenser for a while.
The beer does not ow freely out of the tube. Open the beer tap fully.
The glass is held upright when dispensing. Tilt the glass when dispensing so that the beer
is able to run down the side of the glass.
The CO
2
pressure in the keg is too high. Turn the pressure regulator to the “ ” position.
It takes some time until the pressure in the keg
is relieved and the amount of foam is reduced.
Not enough foam
is produced while
dispensing.
The CO
2
pressure in the keg is too low. Slowly turn the pressure regulator towards “ ”
for 5 seconds.
The beer is too cold. Allow the keg to stand in the dispenser for
while. The temperature is then corrected by
the appliance.
There are grease, washing-up liquid or residues
in the glass.
Wash the glass thoroughly and subsequently
rinse with cold water.
The glass is too warm. Rinse the glass with cold water.
The glass is dry. Rinse the glass with cold water.
The beer turns
cloudy.
The beer is too cold. Allow the keg to stand in the dispenser for
while. The temperature is then corrected by
the appliance.
The beer hose is not clean. Clean the beer hose.
The beer was incorrectly shock- chilled prior to
using the beer dispenser.
Use a correctly chilled keg.
The beer is too warm. The keg was not chilled long enough. Chill the keg longer.
The vents are covered. Insufcient space next to
and behind the dispenser.
Uncover the vents.
Position the dispenser so that there is mini-
mum 15 cm space on all sides.
The beer tastes at. The CO
2
pressure is too low. Slowly turn the pressure regulator towards “ ”
for 5 seconds.
The best before date has expired. Use a new keg.
The keg has been tapped too long. Use a new keg.
The beer runs too
slowly out of the beer
tap.
The CO
2
cartridge is empty. Change the CO
2
cartridge.
The CO
2
pressure in the keg is too low. Slowly turn the pressure regulator towards “ ”
for 5 seconds.
The beer does not ow freely out of the tube. Open the beer tap fully.
The dispenser does
not close.
The dispensing unit is not correctly installed and
protrudes from the dispenser.
Install the dispensing unit correctly.
It is difcult to install
the dispensing unit on
the keg.
The keg tap was not moistened prior to tapping. Wet the keg tap with cold water.
… 50 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clatronic BZ 3740 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clatronic BZ 3740 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info