519303
8
Zoom out
Zoom in
Previous page
1/32
Next page
DCX 18..27
7 Installation(Fortsetzung) Installation(continuation)
Installing connection pieces
1. As shown in the illustration, screw the
cold water connection piece (19) with
the union nut and the 1/2“ seal onto
the cold water connection.
2. Screw the hot water connection piece
(1) with the union nut and the 1/2“ seal
onto the hot water connection.
Installing the appliance
1.To open the appliance hood, take off
the faceplate and unscrew the main
hood screw.
• Whenreplacinganappliance,the
electricalpowersupplycablemaybe
connectedintheupperpart.Onlyin
suchcase,pressagainsttheprepared
breakingpoint(S)withablunt
implement(e.g.screwdriver).
Slitthegrommet(21)tomatchthecable
size.Theopeninginthegrommetshould
beslightlysmallerthanthe
cross-sectionofthecableinorderto
ensureoptimumprotectionagainst
water.Fitthegrommetintotheopening.
Theprotectiongrommetmustbeused!
• Stripthecableroughly6cmabovethe
pointwhereitemergesfromthewall.
Holdthepreparedappliancesothatyou
canroutethecableintothegrommet
withtheotherhand.
2. Place the appliance on the heater
bracket (8) so that the threaded rod
of the wall bracket fits in the provided
hole of the appliance. If necessary,
slight corrections are possible by
carefully bending the threaded rod
of the wall bracket. However, it must
be possible to screw on the water
connection pipes of the appliance
without applying force.
Anschlussstücke installieren
1. Schrauben Sie gemäß Abbildung das
Kaltwasseranschlussstück (19) mit
Überwurfmutter und der 1/2“-Dichtung
an den Kaltwasseranschluss.
2. Schrauben Sie das Warmwasser-
anschlussstück (1) mit Überwurf-
mutter und der 1/2“-Dichtung an den
Warmwasseranschluss.
Gerät montieren
1.ZumÖffnendesGehäusesdieBlende
abnehmen und die zentrale Hauben-
schraube lösen.
•ImAustauschfallkannesvor-
kommen,dassdieElektrozuleitung
imoberenGerätebereichvorhanden
ist.NurdannöffnenSiedieSoll-
bruchstelle(S)anderPrägungdurch
kräftigenDruckmiteinemstumpfen
Werkzeug(z.B.Schraubendreher).
•SchneidenSiedieDurchführungs-
tülle(21)entsprechenddem
Zuleitungsquerschnittauf.Dabei
solldieÖffnunginderTülleetwas
kleineralsderQuerschnittdesKabels
sein,umeinenoptimalenSchutz
gegenWasserzuerzielen.PassenSie
dieTülleindenDurchbruchein.Die
Schutztüllemussverwendetwerden!
•MantelnSiedasElektrokabel
ungefähr6cmüberdemWand-
austrittab.NehmenSiedasvorbe-
reiteteGerätsoindieHand,dassSie
mitderanderenHanddasKabelin
dieGummitülleführenkönnen.
2. Setzen Sie das Gerät auf den Wand-
halter (8), so dass die Gewindestange
des Wandhalters in das vorgesehene
Loch des Gerätes passt. Durch vorsich-
tiges Biegen der Gewinde stange des
Wandhalters lassen sich gegebenen falls
kleine Korrekturen vornehmen. Die
Wasseranschluss leitungen des Gerätes
müssen sich jedoch ohne Gewalt-
anwendung anschrauben lassen.
19
S
1
8
DCX-MA-07-2007a.indd 8 20.07.2007 11:01:11 Uhr
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clage DCX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clage DCX in the language / languages: English, German as an attachment in your email.

The manual is 3,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info