519302
14
Zoom out
Zoom in
Previous page
1/20
Next page
DBX 18..27
Wartungsarbeiten dürfen nur von
einem anerkannten Fach
handwerks-
betrieb durchgeführt werden.
Reinigung und Wechsel des
Filtersiebes
Der Kaltwasseranschluss des Durchlauf-
erhitzers DBX ist mit einem integrierten
Absperrventil und Sieb ausgestattet.
Durch Verschmutzung des Siebes kann die
Warmwasserleistung vermindert werden,
so dass die Reinigung beziehungsweise
der Austausch des Siebes wie folgt
vorzunehmen ist:
1. Schalten Sie den Durchlauferhitzer an
den Haussicherungen spannungsfrei
und sichern Sie diese gegen unbeab-
sichtigtes Wiedereinschalten.
2.NachÖffnenderGerätehaubedrehen
Sie das Absperr ventil (20c) im Kalt-
wasseranschlussstück zu (Position II).
3. Drehen Sie die Verschlussschraube
(20b) aus dem Kaltwasseranschluss-
stück und nehmen Sie das Sieb (20a)
herau s.
4. Das Sieb (20a) kann nun gereinigt
beziehungsweise ersetzt werden.
5.NachEinbaudesSiebesdrehenSiedie
Verschlussschraube (20b) fest.
6. Drehen Sie das Absperrventil (20c) im
Kaltwasseranschlussstück langsam
auf (Position I).
7. Entlüften Sie das Gerät, indem Sie das
zugehörige Warmwasserzapfventil
mehrfach langsam öffnen und
schließen, bis keine Luft mehr aus der
Leitung austritt.
8. Setzen Sie die Gerätehaube auf. Danach
schalten Sie die Spannung an den
Haussicherungen wieder ein.
Maintenance work must only
be conducted by an authorised
professional.
Cleaning and replacing the
filter strainer
The cold water connection of the
instantaneous water heater DBX is
equipped with an integrated shut-off
valve and a strainer. Soiling of the strainer
may reduce the warm water output.
Clean or replace the strainer as follows:
1. De-energize the instantaneous water
heater by means of the house fuses
and prevent inadvertent reactivation of
them.
2. After opening the hood of the unit,
close the shut-off valve (20c) in the cold
water connection piece (position II).
3. Unscrew the screw plug (20b) from the
cold water connection piece and take
out the strainer (20a).
4. The strainer (20a) can now be cleaned
or re placed.
5. After fitting of the strainer tighten the
screw plug (20b).
6. Slowly open the shut-off valve (20c)
in the cold water connection piece
(position I).
7. Vent the unit by carefully opening and
closing the affiliated warm water tap
valve several times until air no longer
emerges from the pipe.
8. Fit the hood of the unit.
Then reconnect the voltage to the
house fuses.
II
I
20a20b
11 Wartungsarbeiten Maintenance work
14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Clage DBX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Clage DBX in the language / languages: English, German as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info