Manual Cisco Cisco SPA112 VoIP (page 65 of 136) (English)

650695

Zoom out

Zoom in

1/136

Configuring the Voice Settings

Regional

Cisco SPA100 Series Administration Guide 73

Interdigit Long Timer Long timeout between entering digits when dialing. The interdigit

timer values are used as defaults when dialing. The

Interdigit_Long_Timer is used after any one digit, if all valid

matching sequences in the dial plan are incomplete as dialed.

Range: 0–64 seconds.

Default setting: 10

Interdigit Short

Timer

Short timeout between entering digits when dialing. The

Interdigit_Short_Timer is used after any one digit, if at least one

matching sequence is complete as dialed, but more dialed digits

would match other as yet incomplete sequences. Range: 0–64

seconds.

Default setting: 3

CPC Delay Delay in seconds after caller hangs up when the ATA starts

removing the tip-and-ring voltage to the attached equipment of the

called party. The range is 0–255 seconds. This feature is generally

used for answer supervision on the caller side to signal to the

attached equipment when the call has been connected (remote end

has answered) or disconnected (remote end has hung up) This

feature should be disabled for the called party (in other words, by

using the same polarity for connected and idle state) and the CPC

feature should be used instead.

Without CPC enabled, reorder tone will is played after a

configurable delay. If CPC is enabled, dial tone will be played

when tip-to-ring voltage is restored. Resolution is 1 second.

Default setting: 2

CPC Duration Duration in seconds for which the tip-to-ring voltage is removed

after the caller hangs up. After that, tip-to-ring voltage is restored

and the dial tone applies if the attached equipment is still off-hook.

CPC is disabled if this value is set to 0. Range: 0 to 1.000 second.

Resolution is 0.001 second.

Default setting: 0.5

Field Description

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Cisco Cisco SPA112 VoIP in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Cisco Cisco SPA112 VoIP Manual

Product: