497619
48
Zoom out
Zoom in
Previous page
1/74
Next page
4-12
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 4 Maintenance and Upgrade Procedures
Removing and Replacing the CompactFlash
Removing and Installing the User CompactFlash
To remove and install the user CompactFlash, perform the following steps:
Note There are two types of CompactFlash release buttons. The release buttons function differently. In this
document we refer to them as Type A and Type B.
Step 1 Locate the user CompactFlash in its slot in the rear panel of the chassis. See Figure 4-13.
Figure 4-13 User CompactFlash and Release Button Location—Type A and B
Step 2
Press the release button, the release button in Type A will pop out towards you. See Figure 4-14.
In Type B pressing the release button once will eject the CompactFlash, the release button will be slightly
extended. See Figure 4-15. If this is the case, skip Step 3 and go to Step 4.
Figure 4-14 Release Button Fully Extended—Type A
1 User CompactFlash in the slot 2 Release button extended
FLASH
CONSOLE
AUX
POWER
STATUS
FLASH
VPN
ACTIVE
1
2
246194
1 User CompactFlash in the slot 2 Release button fully extended
FLASH
CONSOLE
AUX
POWER
STATUS
FLASH
VPN
ACTIVE
1
2
246195
48


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info