497619
45
Zoom out
Zoom in
Previous page
1/74
Next page
4-9
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 4 Maintenance and Upgrade Procedures
Installing the DC Model
Step 8 Insert the ground wire into the connector for the earth ground and tighten the screw on the connector.
See Figure 4-10, and using the same method as for the ground wire, connect the negative wire and then
the positive wire.
Note The DC return connection to this system is to remain isolated from the system frame and chassis.
Figure 4-10 DC-Input Power Supply Connections
Step 9 After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate
power by moving the handle of the circuit breaker to the ON position.
Step 10 Install any remaining interface boards as described in “Installing the DC Model” section on page 4-7.
Step 11 Replace the DC power supply plastic shield.
Step 12 Power on the adaptive security appliance from the switch at the rear of the chassis.
Note If you need to power cycle the DC adaptive security appliance, wait at least 5 seconds between
powering off the adaptive security appliance and powering it back on.
1 Negative 3 Ground
2 Positive
119641
+ –
+ –
1
2
3
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info