497619
44
Zoom out
Zoom in
Previous page
1/74
Next page
4-8
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 4 Maintenance and Upgrade Procedures
Installing the DC Model
Step 1 Read the Regulatory Compliance and Safety Information for the Cisco ASA 5500 Series document.
Step 2 Terminate the DC input wiring on a DC source capable of supplying at least 15 amps. A 15-amp circuit
breaker is required at the 48 VDC facility power source. An easily accessible disconnect device should
be incorporated into the facility wiring.
Step 3 Locate the DC-input terminal box, see Figure 4-9.
Figure 4-9 DC-Input Terminal Box
Step 4
Power off the adaptive security appliance. Ensure that power is removed from the DC circuit. To ensure
that all power is OFF, locate the circuit breaker on the panel board that services the DC circuit, switch
the circuit breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF
position.
Step 5 Remove the DC power supply plastic shield.
Step 6 The adaptive security appliance is equipped with two grounding holes at the side of the chassis, which
you can use to connect a two-hole grounding lug to the adaptive security appliance. Use 8-32 screws to
connect a copper standard barrel grounding lug to the holes. The adaptive security appliance requires a
lug where the distance between the center of each hole is 0.56 inches. A lug is not supplied with the
adaptive security appliance.
Step 7 Strip the ends of the wires for insertion into the power connect lugs on the adaptive security appliance.
1 Negative 3 Ground
2 Positive 4 On/Off switch
119640
+ –
1
4
3
2
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info